|
09-10-2023, 11:49 AM
|
#1 |
|
Not Yet Wild
Join Date: Jul 2023
Posts: 4
|
Starting engine
Hello everyone just completed putting the engine back together and I really wanted to run the engine before I put it back into the golf cart has anyone started one of these engines on the bench? If so how did you start it? Without the starter generator mounted looking for ideas to spin the engine over to get it to start any help would be appreciated
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
09-10-2023, 05:22 PM
|
#2 |
|
Gone Wild
Join Date: Mar 2022
Location: Ohio
Posts: 431
|
Re: Starting engine
I say put it in the cart and start it and the pre mis ratio should be 32to1
|
|
|
|
09-12-2023, 01:16 PM
|
#3 |
|
Gone Wild
Join Date: May 2011
Location: Pittsburgh
Posts: 2,933
|
Re: Starting engine
That's going to be way more effort than it's worth. You would need to fabricate a holder for the motor and the starter. The motor would need to be beefy as those motors put out a lot of torque. It would by much easier to just put the motor back in the cart which, really, doesn't take take all that long.
Spec oil mix is 85 to 1. A bit more or less is ok. Personally, I run 100 to 1. |
|
|
|
|
09-25-2023, 12:04 AM
|
#4 |
|
Gone Wild
Join Date: Aug 2007
Location: North Texas
Posts: 2,312
|
Re: Starting engine
Lochlin is the man to listen to. I think i use 4 oz. per gallon of supertech 2 cycle oil.
|
|
|
|
 |
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Engine starting | Gas Club Car | |||
| G1 starting problem gas engine | Gas Yamaha | |||
| G1 w/ G16 Engine - Hot Starting Issues | Gas Yamaha | |||
| Starting Engine without clutch on the cart? | Gas Club Car | |||
| Engine starting? | Big Block Talk! | |||
Linear Mode
