yama G19E trouble shooting guide???

[Randy018]

My 1st yama,,anyone have a good troubleshooting guide on it? New batteries, no click, no buzzer, nada. Changed solenoid and controller already. Thinking wiring. The diagram I see here stresses me out..Looking for a step by step from A - Z. Any Help?? Thanks

[Randy018]

I bought this cart with the owner saying , just needs batteries,, ha...I have new batteries, pack volts are there. new wires etc. Replaced solenoid and had the stock controller rebuilt by a dealer. I still get zip.. no reverse buzzer, no click.. with my ohm meters ground lead hooked to the main battery ground, I have pack volts to all 4 solenoid posts, that doesnt seem right. The solenoid has a resister and I put a diode as well across the top. The one that was on it did not have a diode. I dont know what volts are correct and where. I have looked for a good trouble shooting guide with no luck. I hate to ask for a hand..anyone? Thanks

[cgtech]

I think Your cart should not have a diode or resistor with a factory controller. How is the fuse near the solenoid?

[Randy018]

the fuse is good cgtech. I will take the diode and resistor off then tomorrow. I have checked most wires for continuity. I just dont know the volt check spots. I have nothing on yamaha. Thanks for any advise.

[Randy018]

CGTECH,, took the diode and resistor off, cart is in operation. I dont understand it, but MANY THANKS for answering and sharing.

[smallblock450sl]

COOL