01-20-2017, 09:07 AM | #1 |
Not Yet Wild
Join Date: Jan 2017
Posts: 4
|
07 Star wiring schematic needed
Hello, I have a Star that runs for a little while then stops. If you let it sit it will go again for a while again then stop. The fwd / rev switch was bad so I replaced it with a factory original. I also bought a new key switch but the new one has 2 wires but 3 screws for connections and the old one has 3 wires. No wiring diagram with the new switch only 3 screws for wires which are marked I, II, & III. I can use the old harness but don't know where the correct wire goes (I foolishly took the wires off the old switch thinking the new one would be an exact replacement). Also none of my 1w volt system is working, lights horn, etc... I am in need of a 2007 wiring schematic for this cart. I do not have the model but I do have the VIN # and other #'s from the plate. Can anyone help? Thanks in advance.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-20-2017, 09:09 AM | #2 |
Not Yet Wild
Join Date: Jan 2017
Posts: 4
|
Re: 07 Star wiring schematic needed
12 volt system not working. Mistakenly put 1w system. I should proof read better.
|
01-24-2017, 08:07 AM | #3 |
Not Yet Wild
Join Date: Jan 2017
Posts: 4
|
Re: 07 Star wiring schematic needed
I guess everyone who has the Star buggies have the same problem. No Support
|
01-24-2017, 09:07 AM | #4 |
Getting Wild
Join Date: Sep 2016
Location: Bel Air, MD
Posts: 140
|
Re: 07 Star wiring schematic needed
what wire colors do you have, and what year cart?
|
02-03-2017, 08:53 AM | #5 |
Not Yet Wild
Join Date: Jan 2017
Posts: 4
|
Re: 07 Star wiring schematic needed
Hello bird6246,
Sorry for the delay. I have been away for a while. At the connector for the key switch on the buggy side, there is a solid yellow, solid red and a purple with white stripe wire. On the key switch side there is a solid blue, solid black and solid red wire. When it is connected the red mates up with the red, the purple with white stripe mates up with the blue and the yellow mates up with the black wire. There are 3 screw connections on the new key switch which are labeled I, II, III and it didn't come with wiring schematic. Any idea as to where the Blue, Black and Red wires connect to the I, II, III on the new key switch? I don't want to cross anything and possibly fry the controller. Also, does the key switch only break the power (I.E. power in only to power out)or does it connect power to ground (I.E. completing the circuit in the switch)? Any help is appreciated. |
02-26-2017, 11:18 AM | #6 |
Not Yet Wild
Join Date: Feb 2017
Posts: 6
|
Re: 07 Star wiring schematic needed
Did you check your relay? It's a little black cube. Might be wrapped in plastic. Or there is a solenoid that comes after your converter
|
02-26-2017, 09:56 PM | #7 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: 07 Star wiring schematic needed
As far as I know, no diagram is around. We were a dealer, and could never get a service manual, parts support, nothing. If you are lucky, yours is equipped with a Curtis controller. At least a diagram is available from Curtis to use for the wires at the controller.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Wiring Schematic for Melex 667 needed | Melex | |||
wiring harness help needed! 2013 star basket case | Star and Fairplay | |||
Wiring schematic EZ-GO PCX 956 needed | Electric EZGO | |||
93 DS Light Kit wiring schematic needed | Gas Club Car | |||
Melex Model 666 wiring schematic needed | Melex |