|
Gas Club Car Gas DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
06-19-2011, 09:15 AM | #1 |
Not Yet Wild
Join Date: Apr 2010
Location: Tucson, AZ
Posts: 22
|
home made clutch removal tool
Well, Happy fathers day for all those fathers that get to do what they choose in this day!!
After installing the lift kit, I found out I need a "SPECIAL" tool to remove the primary clutch, could not wait any longer and decided to make my own tool, it was easier than I thought and the clutch came out like butter, here it is: Home made clutch removal tool: 5/16" thick x 5 3/4" long round stock steel rod (I believe that yamahas and ezgo uses a similar tool just measure the need length for the round rod for your application) and a bolt that will match the thread in the outer shell of the clutch housing, goes in the same hole you put the bolt that holds the clutch. how it works: 1- slide the round rod into the hole in the middle of the clutch housing, when reach the end you will have about a 1/4" between the rod's end and the end of the housing, in the inside to thread the bolt. 2-start tightening the bolt in the housing and as you tighten it the clutch pulls out. 6" Round rod: 1 minute to make and $.03 Fine thread bolt: .25 cents Not having to wait and save $40 + sh, PRICELESS!!! This tool will work for many Club Cars from 88 and up and the same is for other makes just the rod length will vary. |
|
|
Similar Threads | ||||
Thread | Forum | |||
G8 - Home made lift kit | Gas Yamaha | |||
home-made lift kit | Electric EZGO | |||
Clutch removal tool needed? | Gas Yamaha | |||
home made IFS | Lifted Golf Carts | |||
home made posi | Design Center |