|
Design Center Shop tools, fabrication and Paint and Body |
|
Thread Tools | Display Modes |
01-13-2009, 12:41 PM | #1 |
Getting Wild
Join Date: Sep 2008
Posts: 117
|
Newer EZ Go Body on Older EZ Go Cart
Has anybody installed a newer EZ Go body (94 and up I think) on an older EZ Go cart like this:
It may seem stupid but if the price is right. I don't know much about the pre '94 carts by EZ go. What are the differences in controller (or coil?) motors, etc? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-09-2009, 11:51 PM | #2 |
EZ-GO-N
Join Date: Dec 2007
Location: Geneseo, IL
Posts: 505
|
Re: Newer EZ Go Body on Older EZ Go Cart
Yes its possible I have seen it done a lot of times, you are going to need a txt 95+ front dash/glove box assebly to attach the cowl, to but you will have to cut the corners off of your marathon frame because the txt body is not as wide, and then cut the center portion of your new txt dash to fit over the square hump that comes out on the front floor board of your marathong, attach that and then in the rear you are going to have to do a lot of cutting to make everything narrower, you will see when you set the rear body on the frame you will see where you have to chop, later
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
swapping newer powerplant into older cart | Electric EZGO | |||
Newer Cowel for Older EZGO | Electric EZGO | |||
new style body on older cart | Body and Paint | |||
Need a manual or diagram for your newer electric cart? | Electric EZGO |