|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
10-18-2017, 06:40 AM | #1 |
Gone Wild
Join Date: Apr 2015
Posts: 461
|
2006 Ezgo PDS not running
Error code is 3-1 which state check coils replace controller.
Not sure what Checking coils is? Should I try something else before buying a controller? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-18-2017, 08:24 AM | #2 |
Gone Wild
Join Date: Aug 2014
Location: fletcher,nc
Posts: 601
|
Re: 2006 Ezgo PDS not running
more info please-you have no sig to work off of...stock controller? alltrax? ect...
|
10-18-2017, 10:41 AM | #3 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 2006 Ezgo PDS not running
Error code 3-1 is solenoid drive failure, so the coil to check is the solenoid coil.
Remove environmental cover from to access solenoid and controller. With Run/Tow in Run, Keyswitch on and either F or R selected on F/R switch, you should have battery pack voltage (38.2V when fully charged) on the yellow wire and on the blue wire. (Yellow wire is voltage source and the voltage on the blue wire is via an intact coil) When you press the pedal, the voltage on the blue wire ought to drop to Zero and the solenoid ought to click. |
10-19-2017, 06:21 AM | #4 |
Gone Wild
Join Date: Apr 2015
Posts: 461
|
Re: 2006 Ezgo PDS not running
Everything is stock. Brand new batteries. The Pedal Box was replaced but I used the same ITS and Switch inside. Somehow the ITS pegs were broke off to hold it secure.
No solenoid click. |
10-19-2017, 06:26 AM | #5 |
Gone Wild
Join Date: Apr 2015
Posts: 461
|
Re: 2006 Ezgo PDS not running
I have full voltage on yellow wire I have 2 volts less on Blue. Voltage doesn’t change when I push on pedal
|
10-19-2017, 08:50 AM | #6 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,356
|
Re: 2006 Ezgo PDS not running
On the PDS the blue wire will be (+) until the pedal is depressed. Then it will change to (-) and complete the solenoid activation circuit. IF it is not changing from (+) to (-) then the controller has failed. A work around may be to run a new (-) solenoid wire. Disconnect the old one and run a new 16g wire from the solenoid to the battery main negative.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
2006 CC Precedent not running | Electric Club Car | |||
2006 TXT PDS running constantly slow | Electric EZGO | |||
2006 PDS Quits Running | Electric EZGO | |||
2006 Electric EZGO quit running even though fully charged | Electric EZGO | |||
2006 Stoped running | Electric EZGO |