Cable passing through that hole?

[lockman1]

Originally Posted by Speedchaser

Oops, sorry a little too spirited aftet a few brews. Way off topic too. Point is either use a stud or leave existing cable in obc, either will work, decide what is best for you. I would not remove a working obc and switch to dpi, wait til obc takes a dump.

(been there, still doing that!... kinda' why I only reply in the morning! )

[Speedchaser]

Originally Posted by lockman1

(been there, still doing that!... kinda' why I only reply in the morning! )

Yep shoulda known when I had to close one eye to type that it was a bad time to post, lol.

[lockman1]

[scottyb]

You may have coined a new forum term, SC


Nvr mnd, just another 1 eyed post

[Speedchaser]

Originally Posted by scottyb

You may have coined a new forum term, SC


Nvr mnd, just another 1 eyed post

Lol, no one eyed posts!

[scottyb]

Originally Posted by scooterman

Good to know Scotty, batteries these day shave so many characteristics their requirements are all different.

This is very true - even various brand wet cell GC batteries have different charge cycle requirements. Which is why today's smartest chargers like the DPI have several algorithms to choose from. The high cost of batteries demands we get the longest useful life from them. This means each owner should be aware of the best use and care routines. I have put much of this information on my website. I encourage everyone to read and practice it.