Environmental cover and Alltrax

[vagabond]

why didn't this come up 3 days ago, I ended up cutting the bottom section off on the 96

[rib33024]

Originally Posted by kellybell

LOL, but...My girlfriend said that size didn't matter!

That just means in a nice way, it's to small size does matter

[yurtle]

Originally Posted by rib33024

That just means in a nice way, it's to small size does matter

Just buy her an electro-mechanical device to assist.

[UroGator]

Originally Posted by scottyb

If you have ever installed the OEM environmental cover over and aftermarket control like Alltrax or FSI P you are doing the controller a disservice.
These controllers are potted in resin which makes them water resistant. And if you look closely you'll see that they have an aluminum housing with cooling fins cut in them to dissipate heat.
If you have a PDS or DCS cut the controller cover and discard the bottom two thirds. Below is the install sheet I send out with every controller for sepex carts

Is the solenoid water resistant as well?

[scottyb]

Yes - resistant is the key word. None of these electronics are waterproof.
Do not pressure wash them and then call the dealer and ask why the controller quit for no reason.

[mazdawg(Mikey)]

Originally Posted by JohnnieB

This is how my DCX400 was installed when I was running 36V.

hey JohnnyB where did you get that run/tow mount from? it doesnt look homemade

[JohnnieB]

Originally Posted by mazdawg(Mikey)

hey JohnnyB where did you get that run/tow mount from? it doesnt look homemade

PM sent.