|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
02-16-2014, 11:46 AM | #1 |
Not Yet Wild
Join Date: Mar 2011
Posts: 4
|
Universal Turn Signal Install Issues
Bought a Universal Turn Signal Kit from BU for my 95 txt freedom. I have a little better than 12v going into and coming out of the blinker relay and have the white wire properly grounded. The signal indicators on the stem box function and blink properly. However, there is no signal output (12v) from the corresponding wires (or any wire) coming out of the stem box. By that I mean the wires coming out of the turn signal stem housing. Of course, these wires are the ones connected to the factory signal lights via wire loom in dash. Any ideas ?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-16-2014, 02:02 PM | #2 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Universal Turn Signal Install Issues
Quote:
Also, if cart had factory lights without turn signals, you nave to move a couple wires at the rear (brake) lights. See text at bottom of attached wiring diagram. |
|
02-16-2014, 02:09 PM | #3 |
Not Yet Wild
Join Date: Mar 2011
Posts: 4
|
Re: Universal Turn Signal Install Issues
By properly grounded I mean the signal stem housing white wire is attached to a ground found in the dash. Test light used to confirm proper grounding of stem housing. I have the diagram you posted. Still no output (+) on any of the output wires from the housing that are suppose to activate the turn signals.
|
02-16-2014, 02:19 PM | #4 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Universal Turn Signal Install Issues
Okay, just as long as the frame isn't being used for a ground.
Do the brake lights work when Turn signal lever is in neutral? Also, is the parking brake off while testing? |
02-16-2014, 02:22 PM | #5 |
Not Yet Wild
Join Date: Mar 2011
Posts: 4
|
Re: Universal Turn Signal Install Issues
I haven't even messed with the rear turn/brake lights yet. I am just trying to determine if the unit that I purchased is defective. Indicator on stem housing blinks correctly, just no output from ANY of the wires going to the turn signals. Parking brake is off.
|
02-16-2014, 02:40 PM | #6 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Universal Turn Signal Install Issues
Some flashers need to have an amp flow to flash, but it definitely could be a bad unit. New doesn't always mean good.
|
02-16-2014, 03:18 PM | #7 |
Not Yet Wild
Join Date: Mar 2011
Posts: 4
|
Re: Universal Turn Signal Install Issues
It came with a heavy duty thermal flasher. I couldn't even get it to flash. I went out on got an electronic flasher and that is what got me up and going to where I am now.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
plz help universal turn signal with flasher | Gas EZGO | |||
Universal Turn Signal Wiring Questions | Gas EZGO | |||
Universal Turn Signal Swith for Forward/Reverse | Electric EZGO | |||
Universal 7-wire turn signal kit help! | Electric EZGO |