Wiring GTW Universal light kit to Madjax Aplha Body

[fltekdiver]

Wiring GTW Universal light kit to Madjax Aplha Body, 2018 Club Precedent

I've installed many Alpha body kits and always used Madjax part
# 02-006 ultimate light kit and it's plug and play very easy to connect everything up

I cannot find the Madjax #02-006 upgrade kit anywhere due to the Covid shortages, so I was told the GTW upgrade light kit would work so I bought it from the dealer.

I was told I just have to cut the middle wire coming off the 9 pin connector turn signal box, and join it to the blue wire on the Alpha body 9 pin side, which is the 12v+ switched on the Alpha body 9 pin connector.

I thought that's super easy, and the GTW kit is $40 cheaper than the
Mmadjax one so I bought the GTW kit.

Well that didn't work. I can't find the wiring diagram anywhere for the GTW Upgrade light kit part number 32034
I did get turn signals and horn to work, but no headlights or tail lights

I've attached the madjax part number 02-006 Ultimate wiring diagram because this plugs directly to the Alpha Body 9 pin to use as a reference. Ii do know you have to jump a few wires outside the harness over when doing this

I just need the wiring diagram to the GTW 32034 so I know what wires to jump and splice to the Alpha Body light kit which also uses thee 9 pin connector

Thanks !

[fltekdiver]

In case anyone needs this information in the future

The GTW kit plugs right upto the Alpha Body kit 9 pin connector

You take the purple wire that runs down from the turn signal and doesn't go into the GTW control box, its a purple wire separate from the ones going into the control box from GTW .

You connect that purple wire to the Brown wire hanging out of the wires outside the harness on the 9 pin bucket harness side of the Alpha Body kit.

Once you connect the purple wire to the brown wire and plug both 9 pin connectors together everything works like it should.

I ran a separate 12+ switch for the DRL's ( day time running lights ) and they can be swtiched on and off with or without using the headlights

[J2000D]

Is there anyway you can post pictures of how you hooked up your DRL’s?

[fltekdiver]

Originally Posted by J2000D

Is there anyway you can post pictures of how you hooked up your DRL’s?

Sure , off each headlight there's a red wire connected to a blue wire.

Separate the red from the blue wire on each headlight

Now join the 2 red wires one from each headlight together

Run a 12v power wire to a switch on the dash

Then run the wire from the 2 headlights that are one wire now since they were joined together to a 12v switch on/off

Now you have DRL's on a 12v switched power source

[J2000D]

THANKS! Can’t wait to have DRL’s

[fltekdiver]

You bet

[J2000D]

You wouldn’t happen to know witch wire is for the blinkers by any chance?

[squirm88]

Originally Posted by J2000D

You wouldn’t happen to know witch wire is for the blinkers by any chance?

Any chance you figured this out? Trying to tap in LED turn signal side view mirrors to the Alpha harness. Thanks!

[MYCART8A4RE]

Anybody know which wires are for the turn signals yet? We know the blue is headlight and red is DRL going by what fltekdiver stated earlier. Guess it can only be the yellow then as the black would be ground?

[expoman55]

Hey guys any of you hook up a tail gate bar to your Alpha kit ? My rear seat covers a lot of my rear light and Id like to be more visible especially during daylight. I have purchase a traditional tailgate light bar but it appears it may not work with the mad jax kit. I have the standard kit that came from madjax.. not the lux thanks in advance