|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
12-08-2015, 11:07 PM | #1 |
Not Yet Wild
Join Date: Mar 2015
Posts: 14
|
volt meter and rocker switch
Can I hook my digital volt meter directly to the 48v batteries and place a rocker switch inline to enable me to shut off the meter while the cart is on?
I have a 25amp switch on hand that I can use if so, is there any specifics needed for the switch itself? thanks |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
12-08-2015, 11:15 PM | #2 |
Guest
Posts: n/a
|
Re: volt meter and rocker switch
yea you can add a switch
i use a regular switch , don't know the ratings |
12-08-2015, 11:24 PM | #3 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,418
|
Re: volt meter and rocker switch
You can use a 1 amp switch if you can find one that small.
|
12-08-2015, 11:25 PM | #4 |
Not Yet Wild
Join Date: Mar 2015
Posts: 14
|
Re: volt meter and rocker switch
ok thanks.
the switch I have is a 3 prong, I have the meter wired direct to positive and negative of the 48v system, how should the switch be wired in? I know the switch would normally have power in to one terminal, the accessory to another and ground to the third but with just the meters pos/neg terminals I'm not sure if the swith should be grounded... |
12-08-2015, 11:28 PM | #5 |
Not Yet Wild
Join Date: Mar 2015
Posts: 14
|
Re: volt meter and rocker switch
|
12-08-2015, 11:29 PM | #6 |
Guest
Posts: n/a
|
Re: volt meter and rocker switch
on a 3 post switch you have positive in, positive out (accessory) and ground
ground usually lights the switch you would use the positive in and positive out (accessory ) |
12-08-2015, 11:30 PM | #7 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,418
|
Re: volt meter and rocker switch
I'm guessing a the center pin and any end pin would work as an on/off switch - check it out with your meter... As for how to wire it? Cut one of the meter wires and connect the 2 freshly cut wires to the switch
|
12-08-2015, 11:33 PM | #8 |
Not Yet Wild
Join Date: Mar 2015
Posts: 14
|
Re: volt meter and rocker switch
Thanks guys for the quick response... big help.
|
12-08-2015, 11:35 PM | #9 |
Guest
Posts: n/a
|
Re: volt meter and rocker switch
center pin and the non ground pin
ground is usually copper run wire from 48v + to switch then to red wire on meter or 48v - to switch then to black wire on meter |
12-08-2015, 11:47 PM | #10 |
Guest
Posts: n/a
|
Re: volt meter and rocker switch
also the ground and the non accessory pin can be used
|
|
|
Similar Threads | ||||
Thread | Forum | |||
F&R rocker switch keeps going bad | Electric Club Car | |||
98 txt dcs want to convert for switch to dash rocker switch | Electric EZGO | |||
2 wire volt meter to 2 prong key switch. Sounds Simple | Electric Club Car | |||
F/R Rocker switch | Electric EZGO | |||
Is there a 36 volt lighted rocker switch? | Electric EZGO |