|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
02-18-2017, 12:48 PM | #61 | |
Not Yet Wild
Join Date: Jan 2017
Posts: 56
|
Re: Brake switch hook up
Quote:
I just went out and pulled pin from controller and have continuity between 35 pin connector and spade connectors on both red and purple. |
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-18-2017, 01:03 PM | #62 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Brake switch hook up
Heres another idea, try ezgo part number 604110. It's the relay that belongs in that location. I had nothing but bad luck trying other solenoid combos. While I realize the Pwm can be easily adjusted, the inexperienced could likely adjust it to draw too much current. I work at the dealer & found it easiest to just use the intended one. Which I found is also the same relay as the walk-away relay used on older 48v txt style industrial products. They seem to like that relay for outputs on curtis controllers.
|
02-18-2017, 01:08 PM | #63 | |
Not Yet Wild
Join Date: Jan 2017
Posts: 56
|
Re: Brake switch hook up
Quote:
|
|
02-18-2017, 03:46 PM | #64 |
Not Yet Wild
Join Date: Jan 2017
Posts: 56
|
Re: Brake switch hook up
Let me ask a couple question that may better help me understand why this doesn't work
1-If I have 48v coming from the motor on purple/red with key on at a standstill prior to hooking up relay is this correct? 2-After I hook purple/red to relay 85-86 with the key in the on at a standstill what should voltage be? 3- While operating the cart what should volts go down to approximately on 85-86? 4- While braking what should volts be? I have 48v prior to at purple/red being installed on 85-86 then drop down to what I think is -3v at stand still then-6v,-7v while moving and braking. |
02-18-2017, 03:53 PM | #65 | |
Gone Insane
Join Date: Oct 2015
Location: TN/NC/GA Tri-state area
Posts: 3,952
|
Re: Brake switch hook up
Quote:
It is a Tyco Electronics (TE Connectivity) part number VF4-65H11-SO8 Also available from http://www.mouser.com/ProductDetail/.../VF4-65H11-S08 and https://www.arrow.com/en/products/vf...e-connectivity and https://www.tencell.com/products/VF4-65H11-S08.html |
|
02-18-2017, 03:56 PM | #66 | |
Not Yet Wild
Join Date: Jan 2017
Posts: 56
|
Re: Brake switch hook up
Quote:
|
|
02-18-2017, 04:02 PM | #67 | |
Not Yet Wild
Join Date: Jan 2017
Posts: 56
|
Re: Brake switch hook up
Quote:
|
|
02-18-2017, 05:14 PM | #68 | |
Gone Insane
Join Date: Oct 2015
Location: TN/NC/GA Tri-state area
Posts: 3,952
|
Re: Brake switch hook up
Quote:
If you are reading 6 to 7 volts, that is a different matter than if you are reading a tenth of that. The spec for the E-Z-GO relay coil is 360 ohms impedance at the PWM pulse frequency. That works out to be about 317 ohms at DC, which is what an ohm meter reads. The tolerance is +/- 5%. Just go with the brake switch, it'll be easier for you. |
|
02-01-2018, 12:48 PM | #69 |
Not Yet Wild
Join Date: Jan 2014
Location: Crooks, SD
Posts: 5
|
Re: Brake switch hook up
I Connected RHOX LGT 164 to MADJAX 02-18 Ultimate Light Kit Harness on a 2004 Yamaha G22AZ Golf Cart
1. Mount LGT 164 Brake Switch Bracket on left of Brake Peddle and not used the Brake connector Pigtail 2. Brown wire Time Delay to MadJax Yellow Brake wire harness 3. Black Fused Brake Switch wire to MadJax Red Brake Wire harness 4. Black wire Time Delay To MadJax Black Wire Brake wire Harness I did not use the brake bracket, made my own ,mounted in rear of the brake cable bracket and connected brake switch spring to the cable bar where the left and right cables are connected. |
|
|
Similar Threads | ||||
Thread | Forum | |||
2012 Club Car brake light switch under brake pedal pad | Electric Club Car | |||
Brake & Turn Signal Hook Up | Gas Yamaha | |||
Brake Switch | Gas EZGO | |||
Hook up of new HD F/R Switch | Electric Club Car | |||
Brake Light Timer Control Hook Up | Gas EZGO |