|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
11-23-2017, 09:57 AM
|
#1 |
|
Gone Wild
Join Date: Jun 2014
Location: NC
Posts: 192
|
Removing Dash on RXV
Trying to install a new SOC/voltmeter in my RXV but struggling to remove the dash. I've got the 4 torx bolts out from under the lip but the dash seems to be hung up. I can tilt the dash to gain access but it is very tight and will be hard to get the meter clamp nuts tightened properly. What's the trick?
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
11-23-2017, 10:10 AM
|
#2 | |
|
Gone Wild
 Join Date: Mar 2014
Location: NE Indiana & SW Florida
Posts: 3,233
|
Re: Removing Dash on RXV
Quote:
You'll need to loosen or remove the two side plates above the rocker panels with a T45 torx. There are clips or fasteners on both sides of that dash. Just give it a quick jerk and they will pop out. |
|
|
|
|
|
11-23-2017, 10:20 AM
|
#3 |
|
Gone Wild
Join Date: Jun 2014
Location: NC
Posts: 192
|
Re: Removing Dash on RXV
Thanks, usgicollector! Got that side to where I can work with it. About to drill the 1/2" hole for the selector button.
|
|
|
|
|
11-23-2017, 10:33 AM
|
#4 |
|
Gone Wild
Join Date: Jun 2014
Location: NC
Posts: 192
|
Re: Removing Dash on RXV
I'm wondering if the polarity of the connections to the button matter. The terminals aren't marked but the wires are red & black. I'll need to remove them to do the button install. Sure don't want to make a mistake and fry the controller.
|
|
|
|
|
11-23-2017, 10:43 AM
|
#5 |
|
Gone Wild
Join Date: Mar 2014
Location: NE Indiana & SW Florida
Posts: 3,233
|
Re: Removing Dash on RXV
Your doing just fine. Just make sure key is off and in tow mode.
|
|
|
|
|
11-23-2017, 11:22 AM
|
#6 |
|
Gone Wild
Join Date: Jun 2014
Location: NC
Posts: 192
|
Re: Removing Dash on RXV
All was going smoothly until the fastening nut on the button went missing. Can't reassemble until I find it or replace which couldn't be until tomorrow.
|
|
|
|
|
11-23-2017, 11:31 AM
|
#7 |
|
Getting Wild
Join Date: Mar 2017
Location: Windsor, Co
Posts: 110
|
Re: Removing Dash on RXV
If it fell behind the dash, chances are it landed on the flat by the wires or under the cubby
|
|
|
|
|
11-23-2017, 11:35 AM
|
#8 |
|
Gone Wild
Join Date: Mar 2014
Location: NE Indiana & SW Florida
Posts: 3,233
|
Re: Removing Dash on RXV
It's amazing where those small pieces hide at times. Well it will be tomorrow before you know it.
|
|
|
|
|
11-23-2017, 11:37 AM
|
#9 | |
|
Gone Wild
Join Date: Mar 2014
Location: NE Indiana & SW Florida
Posts: 3,233
|
Re: Removing Dash on RXV
Quote:
Three nuts hold the cup holder on. Very easy to remove. |
|
|
|
|
|
11-23-2017, 11:38 AM
|
#10 |
|
Getting Wild
Join Date: Mar 2017
Location: Windsor, Co
Posts: 110
|
Re: Removing Dash on RXV
Those things get lost easy too lol, I ran mine for a while with just the 1 nut in the front on as I couldn’t find the other 2
|
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Removing and replacing 12V in dash charger | Gas EZGO | |||
| Need help removing the fan nut | Gas Columbia ParCar | |||
| Removing dash board from txt | Gas EZGO | |||
| Removing dash on E Z Go | Electric EZGO | |||
| Club Car Dash - Lockable Dash Insert Doors for Sale | Golf Carts and Parts | |||
Linear Mode
