|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
09-17-2018, 09:39 PM | #1 |
Not Yet Wild
Join Date: Sep 2018
Posts: 4
|
Ezgo rxv solenoid
I’m hooking a voltage reducer up and I was wondering if anyone recommends hooking it up to the solenoid instead of the key switch and if I should hook to solenoid which post should I hook it up too ! Thanks
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-17-2018, 10:18 PM | #2 | |
Gone Insane
Join Date: Oct 2015
Location: TN/NC/GA Tri-state area
Posts: 3,952
|
Re: Ezgo rxv solenoid
Quote:
Disconnect the +48V cable to the solenoid from the + battery pack terminal. Never mess with the keyswitch wiring. You would install a 1/4" ring terminal onto the voltage reducers +48V input wire, and add it to the top of the stack of wires under the 6mm flange bolt at the B+ terminal on the RXV controller. Messing with the nuts on the solenoid itself risks rotating the solenoid stud and causing damage to the solenoid. Reconnect the +48V solenoid cable to the battery pack +terminal. Do not ruturn the run/tow switch to run until all wiring changes are finished... |
|
09-17-2018, 10:33 PM | #3 |
Not Yet Wild
Join Date: Sep 2018
Posts: 4
|
Re: Ezgo rxv solenoid
Which one of these posts on the solenoid would I hook it too
|
09-17-2018, 11:59 PM | #4 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Ezgo rxv solenoid
The large red wire that goes from the solenoid to the controller.
|
09-18-2018, 06:32 AM | #5 |
Not Yet Wild
Join Date: Sep 2018
Posts: 4
|
Re: Ezgo rxv solenoid
Right or left in that photo
|
09-18-2018, 02:09 PM | #6 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Ezgo rxv solenoid
You will have to follow the cable from the solenoid. One will go to the batteries, the other will curve down to the controller. The pic is not inclusive enough for me to tell. You want to use the terminal that goes to the controller.
|
09-18-2018, 05:36 PM | #7 |
Not Yet Wild
Join Date: Sep 2018
Posts: 4
|
Re: Ezgo rxv solenoid
But it will be one of the red wires correct ?
|
09-18-2018, 06:31 PM | #8 |
Gone Wild
Join Date: Jul 2010
Location: Peachtree City, Ga.
Posts: 2,759
|
Re: Ezgo rxv solenoid
#2 in the picture. But read the instructions posted by Bob in post #2 very carefully.
|
09-19-2018, 01:20 AM | #9 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Ezgo rxv solenoid
The picture shown here actually has the terminals inverted of what he is showing. Might have actually confused it more. Tried to describe it as simple as could be. Maybe this is a job for the pros?
|
10-16-2018, 09:02 AM | #10 |
Not Yet Wild
Join Date: Aug 2018
Posts: 2
|
Re: Ezgo rxv solenoid
I've got my controller hooked up to the small terminal....everything works fine. It's a 30 amp controller but I'm pulling very little amperage from it (50W Bluetooth amp and ProLine LED light kit). Any problems ya'll foresee with that setup?
|
|
|
Similar Threads | ||||
Thread | Forum | |||
94 ezgo solenoid help | Gas EZGO | |||
97 Ezgo Solenoid | Gas EZGO | |||
Need solenoid for 81 ezgo | Gas EZGO | |||
Do I have a bad Solenoid '88 EzGo | Electric EZGO | |||
ezgo solenoid help | Gas EZGO |