EXGO TXT charging issue

[tag0401]

Originally Posted by BobBoyce

Put it back on charge right away, and let it run. It will charge until the pack voltage reaches a typical voltage of 60V +/- 1V.

Check electrolyte level and add distilled water to 1/4" to 3/8" above the plates on all cells. Do not overfill, liquid level rises while charging, especially while bubbling (it is not the same as boiling) towards the end. The bubbling is required to stir the electrolyte and eliminate stratification, for best battery life.

Charger finally showed a complete charge. Still only 52 volts is this to be expected I see you said I should get to ~ 60 volts?

[yurtle]

How soon after charger completed did you measure 52 volts? After 12 hours you should read 50.93 or so. You may need to do several back to back charges. Unplug charger from cart, then replug it to cart. Allow to complete, repeat.

[tag0401]

Originally Posted by yurtle

How soon after charger completed did you measure 52 volts? After 12 hours you should read 50.93 or so. You may need to do several back to back charges. Unplug charger from cart, then replug it to cart. Allow to complete, repeat.

It was within a two hour window. And I did unplug and replug so it is charging again.

[cgtech]

Originally Posted by tag0401

Even though it charged all night and most of today except between 10 and 2 when i drove it around?

Yep

[Cobra,1]

Tag the “60” volt number is what charger puts out,not what battery voltage should be��