|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
02-12-2013, 10:22 AM | #1 |
Gone Wild
Join Date: Feb 2012
Location: Indio, CA The Desert!
Posts: 1,263
|
precedent light kit, Do i need a reducer?
2010 precedent, with six 8 volt batteries. This cart is a excel cart, number starts with "PH".
Since this is a fleet cart, this is my question: I want to add a light kit. I understand that i need to buy a wiring harness/bucket kit. BUT do i also need to buy a voltage reducer, since I have 8 volt batteries? Or will the bucket/wiring harness feed 12 volts to my lights without me having to also add a reducer? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-12-2013, 11:24 AM | #2 |
Medicare Recipient
Join Date: Jun 2011
Location: West Michigan
Posts: 3,541
|
Re: precedent light kit, Do i need a reducer?
. . . with 6 8v batteries, with no factory installed reducer, there is no way to provide 12v to your accessories unless you add/install a 48-12v reducer yourself . . . with no reducer, you can only provide 8v, 16v, 32v or 48v to your 12v lights, depending which positive battery terminal you connect the "hot" wire from lights to . . .
|
02-12-2013, 03:39 PM | #3 |
Gone Wild
Join Date: Feb 2012
Location: Indio, CA The Desert!
Posts: 1,263
|
Re: precedent light kit, Do i need a reducer?
ok thanks for your time and knowledge.
|
02-12-2013, 04:11 PM | #4 |
Gone Wild
Join Date: Feb 2010
Location: Florida
Posts: 184
|
Re: precedent light kit, Do i need a reducer?
If you buy an afermarket light kit from someone like MadJax or others, you will need a 16V-12V reducer that plugs into the factory harness or you can get a 48V-12V reducer. I have a 2010 precedent I2L Excel, serial number starts with PD, and it has the madjax light kit. You have to install the bucket harness and the reducer. You can check the installation instructions at: http://www.mymadjax.com/file/BucketH...all2011Rev.pdf. The plug and play voltage reducer is here: http://www.diygolfcart.com/Club-Car-.../volt-0011.htm. It plugs right into the factory harness.
|
02-12-2013, 04:32 PM | #5 |
Gone Wild
Join Date: Mar 2012
Location: Cullman, AL/Destin, FL
Posts: 268
|
Re: precedent light kit, Do i need a reducer?
I would go with the 48v to 12v reducer. IMO...It is better to pull from the entire pack than just 2 batteries. Pulling from only 2 batteries could effect the consistency of the pack over time depending on the amount light usage.
|
02-12-2013, 07:24 PM | #6 |
Not Yet Wild
Join Date: Aug 2012
Location: Louisville, KY
Posts: 25
|
Re: precedent light kit, Do i need a reducer?
Here's a follow up question: if I plan to wire in 12v lights and I have four 12v batteries, and if I plan to practically never use the lights (emergencies only), is there any harm in just wiring them to one battery? If not, which battery in the series gets nominated?
|
02-12-2013, 08:21 PM | #7 |
haveacupofshutthe****up
Join Date: Jun 2011
Location: Viera, FL
Posts: 739
|
Re: precedent light kit, Do i need a reducer?
Agreed. If you are gonna buy a converter, go with 48-12, not 16 to 12. It may cost a little more, but well worth it in the long run. Put a switch on it, so it's not on all the time.
|
02-13-2013, 05:12 PM | #8 |
Gone Wild
Join Date: Feb 2010
Location: Florida
Posts: 184
|
Re: precedent light kit, Do i need a reducer?
I agree 48V is the best option. Club car has a plug and play 48V-12V converter for the precedent, part no. 102553102. TahoeDawgZ71 hooked me up on where to get one. Thanks so much David. I just installed this afternoon. It was very easy. I've attached a pic of what you get in the kit. The converter just plugs into the wiring harness between the 12 pin connectors.
|
02-25-2013, 12:10 PM | #9 |
Not Yet Wild
Join Date: Feb 2013
Location: Goode VA
Posts: 2
|
Re: precedent light kit, Do i need a reducer?
Hello, where would one go to find the plug and play 48V-12V converter for the precedent, part no. 102553102.. Just finished installing lights on a 07 and was looking for one. Thanks
|
02-25-2013, 12:13 PM | #10 |
Gone Wild
Join Date: Feb 2010
Location: Florida
Posts: 184
|
Re: precedent light kit, Do i need a reducer?
Check with TahoeDawgZ71. He can get tell you where to get one. I am also sure any club car dealer can. But check with him first. He is the Club Car man.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Precedent Light Kit Install w/ Voltage Reducer | Electric Club Car | |||
08 Precedent Voltage reducer location? | Electric Club Car | |||
Precedent Light Kit Installation – Tail Light Question | Electric Club Car | |||
Precedent light kit | Electric Club Car | |||
Voltage reducer question 05 precedent | Electric Club Car |