|
03-31-2012, 10:24 PM
|
#1 |
|
Gone Wild
Join Date: May 2009
Posts: 377
|
frustrating problem
I'm working on a 95 ezgo had fuel in the oil so I cleaned the carb now it has a major hesitation when you get into it. If you ease into it slowly it runs great. It ran fine before. I took carb apart twice more, checked fuel pump. Cant figure out my problem. Other than I should have left it alone.any ideas? Thanks
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
03-31-2012, 11:12 PM
|
#2 |
|
Not Yet Wild
Join Date: Mar 2012
Location: Tx
Posts: 12
|
Re: frustrating problem
Had the exact same problem.Pull the valve cover and look at the push rods.Make sure their sitting properly I had one bent and slipped out of the lifter.I took it out carefully bent it straight and replaced it it then fired up like a champ.Hope this helps and yes very frustrating!
 |
|
|
|
 |
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Frustrating Problem!! <follow-up> | Electric Club Car | |||
| Good problem bad problem | Big Block Talk! | |||
| frustrating flathead | Gas Club Car | |||
Linear Mode
