07-22-2017, 09:11 PM | #31 |
Not Yet Wild
Join Date: Jul 2017
Posts: 8
|
Re: Golf Cart Mod
It's an old E-Z-Go frame modified for a Club Car body. Old rear end and swing arm was ripped out and a whole new one Refabbed with a live axle. You are correct too much Gear with the clutch on the axle and it won't take off. Not enough room for the jackshaft above the rear end with the body on. Easy to move the motor forward. Just purchased 14 tooth and a 72 tooth sprocket to start with.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-22-2017, 09:30 PM | #32 | |
Gone Wild
Join Date: Dec 2010
Location: Woodstock,GA
Posts: 1,088
|
Re: Golf Cart Mod
[quote=Shepard;1411130]
Quote:
you have to remember he is using a 2 stroke sled engine not a 4 stroke that has bottom end power. Most sled clutches don't even start to engage till 3500-3700 rpm's on sleds. I just don't think a 4 to 1 on 22's will work here. I have played with 2 sled cart's, one we geared to high and the other to low. And the 6 to 1 would be in the middle of those two carts. We have played and played with these cart trying to get it right. the power ban on these engines is very short. But then again, we are trying to drag race on a 300-400 foot track. |
|
07-22-2017, 09:44 PM | #33 | |
Gone Wild
Join Date: Dec 2010
Location: Woodstock,GA
Posts: 1,088
|
Re: Golf Cart Mod
Quote:
That's 5.14 ratio with 22 6000 rpm's tops at 38.17 MPH. But that's saying your clutch set up is 1 to 1. Using a sled front and cart rear clutch I don't know what it actually is. But I am thinking it is going to be an overdrive not 1 to 1. With a 15% overdrive would put you at 43.9 mph. Make sure you come back and tell us how it worked. Or we still will be having this debate! Worst case, if you still have the gas rear and swing arm you could put high speed gears 6 to 1 and I think you would be there. If I build a another one with sled engine that what I am going to do. |
|
07-22-2017, 10:02 PM | #34 | |
Gone Wild
Join Date: Dec 2010
Location: Woodstock,GA
Posts: 1,088
|
Re: Golf Cart Mod
Quote:
|
|
07-23-2017, 08:49 AM | #35 |
Gone Wild
Join Date: Dec 2010
Location: Woodstock,GA
Posts: 1,088
|
Re: Golf Cart Mod
Anyone else want to chime in here, Maybe someone with better math skills then me,
Or anyone who has built one with a sled engine. Tell us how you geared it and the out come? |
07-23-2017, 03:06 PM | #36 |
VC 460 CLONE GONE WILD
Join Date: Oct 2014
Location: Ray BY The Bay NJ
Posts: 10,639
|
Re: Golf Cart Mod
I looked up the harley carts final ratio. It is 12.25:1. I am running 20" tires and could use higher gearing. Based on your running 22 " tires I would start with an 8:1 ratio. This should be very close what would be a nice ratio for a golf cart. Also note harley claims a cvt ratio of 3.39 low to a 1.17 high. I think with the snowmobile primary clutch these ratios have been altered to higher ratios. I hope this helps you figure out where to gear at.
|
07-23-2017, 07:39 PM | #37 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,445
|
Re: Golf Cart Mod
I would agree with that, most of the time they don't run right because they are not clutched right. A good sled you hit the gas it engages at say 4K WOT and the sled moves (with picks there is no spinning) and in say 20' the tack goes up to 7K rpm you shift at, it stays at 7K until you hit top speed of say 90mph for a 500cc typical old sled. This would tell you the torque is up at 4K rpm though it peaks right under the HP usually in a 2 stroke like that. But with a sled you spin if too much power so they do it that way. A drag sled would engage at higher rpm and thus more power on holeshot. Drag sleds suck on trails to ride! rpm high all the time, not fun to ride other than WOT usually. So you find a compromise. Either way it needs to hit 7K stock shift rpm or you wont get the power it has. It should be 7K all the time at WOT to get power to ground...or whatever rpm your engine runs normally. I think my srv ran 7200 for max power but that was long ago not sure and it had a psi pipe.
Sleds usually have a larger secondary diameter to give a wider range than carts have, so they can get more low end gearing to go slow and still run fast. Most carts they will hit the axle if you could fit one on there. On the other hand if you don't need all the power or change the pipe then if may not need to be spot on and make max power. With a sled your buddy goes by you if its messed up. |
|
|
Similar Threads | ||||
Thread | Forum | |||
Western Golf Cart Golf Bag Holders | Electric EZGO | |||
Golf Cart: Melex Electric Golf Cart - $75 | Golf Carts and Parts |