|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
04-12-2010, 03:23 PM | #1 |
Not Yet Wild
Join Date: Mar 2010
Posts: 17
|
Lifted ezgo engine oil specs
Hey guys! I have a 2001 ezgo shuttle 2+2 with a 2 inch heavy duty spring lift and a 4 inch additional lift.(6 inches in all) I'm trying to figure out how much oil I should put in so that the engine oil level will be correct with the new engine angle. Also the engine is a 295cc. Thanks in advance for any help!
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-12-2010, 03:29 PM | #2 |
Gone Wild
Join Date: Aug 2009
Location: Santuck,Al
Posts: 1,747
|
Re: Lifted ezgo engine oil specs
Only put 1 1/2 quarts in it after it is lifted.
|
04-12-2010, 03:35 PM | #3 |
Gone Wild
Join Date: Aug 2009
Location: Santuck,Al
Posts: 1,747
|
Re: Lifted ezgo engine oil specs
Also when you put the 1 1/2 quarts in have the cart on a level surface,check and mark the dipstick;this will be your new full line to use when checking the oil level.If you run more than 1 1/2 quarts and climb any decent hills at all the crankshaft will cause the oil to foam and wind up in your breather box then into the intake.
|
04-12-2010, 03:44 PM | #4 |
Not Yet Wild
Join Date: Mar 2010
Posts: 17
|
Re: Lifted ezgo engine oil specs
Thanks for the quick response. I will do. As for the oil level, it is registering at the old low mark with 1.5 qts of oil. I guess i'll use that as my new full mark. If I cleaned the filter do I need to reprime oill pump or is it all right? Thanks again!
|
04-12-2010, 03:54 PM | #5 |
Gone Wild
Join Date: Aug 2009
Location: Santuck,Al
Posts: 1,747
|
Re: Lifted ezgo engine oil specs
As long as you drained the old oil out,cleaned the filter and added the 1 1/2 qts of new oil you should be good to go and no I have never had a problem with the oil pump needing to be re-primed;just be sure the cart is on a level surface and if it has been run since you changed it give it a minute to run back into the pan before checking for your new mark.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
92 club car engine torq specs | Gas Club Car | |||
oil specs for a kf82 engine | Gas Club Car | |||
engine specs (measurements) | Gas Club Car | |||
90 Gas Engine Shaft Specs | Gas Club Car | |||
99 Ezgo 350 engine specs | Gas EZGO |