01-22-2015, 05:59 PM | #1 |
Gone Wild
Join Date: Jul 2014
Posts: 314
|
Piston out
I just remover the piston from my 2000 FE290d engine witch was smoking but ran...I took 2 measurments with a tool I got for ID measuring and the top of the cylinder about 1/4 inch down was 3.72 and a little lower was 3.79....od of piston is 3.50 on top and 3.60 on bottom.so is this a stock piston and rings?
If so here is my question.if it is stock can I just hone the cylinder out a little and go with stock rings or do they make over size rings for a stock piston if so what do I need to get???? please |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-22-2015, 07:04 PM | #2 |
Professional jerry rigger
Join Date: May 2012
Location: illinois
Posts: 337
|
Re: Piston out
ive seen tapered cylinders before but those measurements are quite a bit over. lots of scoring in it im guessing? lines/scratches up and down with the piston movement?
unsure if you can get a replacement cylinder for the kawasaki but I would think its how id go if the block allows it. might take a machine shop to press it out and new in. still wanting my motor? |
01-22-2015, 07:23 PM | #3 |
Gone Wild
Join Date: Jul 2014
Posts: 314
|
Re: Piston out
Yes im just going to maybe try and rebuild this engine because I found another CC that has a blown engine.and yes I am still going to buy your engine!!
|
01-22-2015, 07:24 PM | #4 |
Gone Wild
Join Date: Apr 2014
Location: Flint, MI, USA
Posts: 656
|
Re: Piston out
|
01-22-2015, 07:25 PM | #5 |
Gone Wild
Join Date: Jul 2014
Posts: 314
|
Re: Piston out
no the cylinder bore is in good shape.no maring or scrathing on the walls just smooth and not bad at all
|
01-22-2015, 07:30 PM | #6 |
Gone Wild
Join Date: Dec 2009
Location: Corpus Christi, TX
Posts: 1,644
|
Re: Piston out
You mean a new cylinder sleeve?
|
01-22-2015, 07:38 PM | #7 |
Not Yet Wild
Join Date: Jun 2014
Posts: 13
|
Re: Piston out
I would take the block to a good automotive machine shop and let them mic it. They will tell you if honing will work or if it needs to be bored.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
3pg piston help please | Gas EZGO | |||
piston | Gas EZGO | |||
G1 piston and jug | Gas Yamaha | |||
piston | Gas Club Car | |||
g1 piston | Gas Yamaha |