|
09-19-2014, 09:42 AM
|
#1 |
|
Getting Wild
Join Date: Jan 2014
Location: Mechanicsville, VA
Posts: 77
|
Engine won't stop
Here's my issue. Just bought a '00 DS gas, starts fine, seems to go wide open immediately, let your foot off the gas and keeps going. Key will shut it off. I replaced the micro switch shown in photo, no change. I verified that the black wire is grounded (continuity to chassis) when in this position shown in photo. I also verified continuity from green to orange when gas pedal is pushed. I also noticed that the rev limiter brown wire was disconnected and taped. Any ideas of why it won't stop running? Also, what is the small square alum block in the upper left of this photo?
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
09-19-2014, 12:11 PM
|
#2 |
|
Not Yet Wild
Join Date: Apr 2014
Posts: 68
|
Re: Engine won't stop
There are two switches there. On my 91 it's the bottom one that controls this. I'm assuming it's the same on a 2000.
|
|
|
|
|
09-19-2014, 02:42 PM
|
#3 |
|
Getting Wild
Join Date: Jan 2014
Location: Mechanicsville, VA
Posts: 77
|
Re: Engine won't stop
Yes, there are two, and I replaced them both even though they both ohmed out ok. Any ideas?
|
|
|
|
|
09-19-2014, 07:12 PM
|
#4 |
|
Not Yet Wild
Join Date: Apr 2014
Posts: 68
|
Re: Engine won't stop
Only thing i can think of is the accelerator rod under the driver side may be adjusted to long so it's not engaging the switch.. Or maybe some wires are swapped.
|
|
|
|
 |
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Engine keeps running after I stop | Gas Yamaha | |||
| G29 runs without engine stop relay | Gas Yamaha | |||
| what causes the engine to run on or diesel after you come to a stop | Gas EZGO | |||
| Engine stop relay location | Gas Yamaha | |||
Linear Mode
