regenatrive braking on 2010 model?

[Sergio]

You need to buy a series of 3 x 3-digit codes (A, B and C) from Club Car for each Controller to allow your IQDM to select the speed code 4.

If You see a sticker with the codes, You can enter them on the IQDM to unlock that setting.

Do not try to guess the numbers as the setting gets permanently disabled after 3 wrong attempts.

If You are measuring the Controller voltage with the Solenoid OFF, the voltage on Controller B+ is being reduced by the voltage drop across the pre-charge resistor.

As soon as the Solenoid closes, the voltages should be pretty much the same.

[stoker]

Originally Posted by Sergio

You need to buy a series of 3 x 3-digit codes (A, B and C) from Club Car for each Controller to allow your IQDM to select the speed code 4.
how much speed diff between 3 and 4?

If You see a sticker with the codes, You can enter them on the IQDM to unlock that setting.
where would this sticker be?

Do not try to guess the numbers as the setting gets permanently disabled after 3 wrong attempts.

If You are measuring the Controller voltage with the Solenoid OFF, the voltage on Controller B+ is being reduced by the voltage drop across the pre-charge resistor.

As soon as the Solenoid closes, the voltages should be pretty much the same.

so,if i depress go petal till selonoid clicks,it should jump up the one volt difference?
THANKS

[Sergio]

Speed codes for Precedent:




Location of label if the codes were purchased:




Yes, as soon as the Solenoid clicks the voltages should be the same as Controller B+ will be directly connected to the pack positive.

You are welcome

[stoker]

come to find out this IQDM-p that i borrowed is actually a controller Diagnostic tool 1313-4404 (CDT).i would like to learn it everything about it

[mjroman20]

Originally Posted by stoker

come to find out this IQDM-p that i borrowed is actually a controller Diagnostic tool 1313-4404 (CDT).i would like to learn it everything about it

http://www.fsip.biz/Documents/1313%2...e%20Manual.pdf