New 2 cycle ez go owner looking for any mods/info

[Sean5545]

Hey guys, new member here. I just picked up a 2 cycle ez go (circa 1981-198. First off I will say this forum is a wealth of information so far I've used the knowledge of the members to, 1--install a missing spring on my throttle cable eliminating the backfiring/touchy throttle issues I was having. 2--did the oil pump elimination mod 3--solve my driven clutch wobble issue (missing bolts on the stationary plate) 4--disassembled my drive clutch, cleaned and inspected. I don't have any specific questions, I am however looking for advice on what people are doing to these to make them perform at their best. The only outstanding issues I have are 1--missing low end adjustment screw on carburetor (new carb ordered problem solved with the help of this forum once again) 2---leaking oil seal at the differential side of the input shaft (no action taken yet) 3---driven clutch noise at low speeds. (No solutions yet). Any information anyone cares to share would be greatly appreciated, these answers are out here already I'm sure I simply don't know what I'm looking for lol...thanks in advance everyone

[Sean5545]

As a follow up I just ordered 2 Monroe 5752 shocks for the back of this rig...the measurements on the spec sheet seem pretty close and at 18 bucks each I couldn't beat it....anyone do this before? I'm still on the hunt for front shocks the spec book from Monroe is 81 pages long :(