08-08-2018, 08:52 AM | #1 |
Gone Wild
Join Date: Mar 2018
Location: South FL
Posts: 244
|
RPM Litmiter
Has anyone had issues with the RPM Limiter on a Club Car 92-96?
I have a 94 and i think i finally trouble shooted it down to the RPM limiter, the governor seems to be working correctly after i replaced the cable due to age and wear & tear. The cart jumps high in RPMs and is bouncing off limiter @ 14-15 mph. the governor is not exactly where i need it to be so i know there is more adjustning but has anyone had this problem with the limiter? I am going to disconnect the ground on the limiter when i get home today and see if that takes care of my problem but i dont want to leave it off becuase i dont need someone else thats driving to gernade my motor. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-08-2018, 09:31 AM | #2 |
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,176
|
Re: RPM Litmiter
With stock wheels and tires 14-15 is about right. Loosen up on the governor until it quits and you should be fine
|
08-08-2018, 09:43 AM | #3 |
Not Yet Wild
Join Date: Jul 2012
Posts: 4
|
Re: RPM Litmiter
As long as you don't have any wild drivers that want to see how fast you can go I would leave it off.
|
08-09-2018, 12:22 PM | #4 |
Gone Wild
Join Date: Mar 2018
Location: South FL
Posts: 244
|
Re: RPM Litmiter
i have a lift and 22x11x10 tires. any idea what the speed would be? i will turn back my throttle cable so i dont blow the motor.
|
08-09-2018, 06:51 PM | #5 |
Gone Wild
Join Date: Oct 2009
Location: Lee County, Georgia
Posts: 521
|
Re: RPM Litmiter
If your clutches are not opening and closing as they should,as in stuck, you will hit the rpm limiter at a lower speed. Put it in maintenance mode and check clutch operation.
Maintenance Mode: Lift up the seat look on the back side of the shifter. Theirs a white knob as you move the shifter from F to R you can see it activate the micro switches. Pull the knob out and turn it 180 degrees now it will start in neutral and not in F or R |
08-10-2018, 08:23 AM | #6 |
Gone Wild
Join Date: Mar 2018
Location: South FL
Posts: 244
|
Re: RPM Litmiter
my clutch is operating fine. ive been debating to upgrade but i may end up getting a new cart in the near future. i am going to give the cart a test run today and set the throttle cable to about 22-25 mph
|