|
Gas Club Car Gas DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
10-27-2018, 10:54 PM | #1 |
Not Yet Wild
Join Date: Oct 2018
Posts: 10
|
wont start when ignition wire is hooked up
Hello,
i just bought a club car gas burner.It is a engine that will idle not one you have to press gas to start. The guy that had it installed a 420 cc engine and hadn't wired up key or fuel pump so i installed a new key switch and hooked it up the way switch said to. It will turn over but wont start. But will start if i have ignition wire unhooked. But i cant kill it like that. Is there something i am missing or what do i need to do?? Thanks in advance |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-28-2018, 05:16 AM | #2 |
Gone Wild
Join Date: Jun 2011
Location: Northern Indiana
Posts: 2,827
|
Re: wont start when ignition wire is hooked up
Most all clones (and the OE engine in that Club Car) have a magneto type ignition. It uses the magnet spinning past on the flywheel to produce the electricity it fires the spark with. The small wire off of that ignition coil is a "kill" wire. It's function is to direct the spark to ground and shut the engine down when called for. That "ignition wire" can't be hooked up with the starter /solenoid system and function.
|
10-28-2018, 06:56 PM | #3 |
Not Yet Wild
Join Date: Oct 2018
Posts: 10
|
Re: wont start when ignition wire is hooked up
Ok thanks for info
|
10-28-2018, 09:15 PM | #4 |
Bonafide Nincompoop
Join Date: Dec 2015
Location: Charlottesburg Va
Posts: 8,987
|
Re: wont start when ignition wire is hooked up
You didn’t get a club car switch did you?
The original key switch has multiple contacts and the Off position is connected to ground and grounds the kill circuit for the ignition. The easiest way for you would be to install a 5 pin relay with the NC pin on the relay connected to the kill circuit. The common pin connected to frame ground. Power for the relay can come from the solenoid output post (white wire connected to + on the starter) Or can come from the key switch On position. |
10-28-2018, 09:20 PM | #5 |
Not Yet Wild
Join Date: Oct 2018
Posts: 10
|
Re: wont start when ignition wire is hooked up
Nah I bought a 4 pin from autozone. So I will go buy a 5 pin if that’s what I need. Thanks for the help
|
|
|
Similar Threads | ||||
Thread | Forum | |||
G29 Ignition Wire?? | Electric Yamaha | |||
2008 RXV wont run with neg charger hooked up | Electric EZGO | |||
No wire hooked up to my ignitor | Gas Club Car | |||
Which is the 'Hot Wire' on the Key Ignition? | Electric Yamaha | |||
Ignition Coil Wire | Gas EZGO |