stock front brake help

[4vertical]

I am attempting to retrofit a cable front brake system on my ds golf cart. It was pulled from a carryall.

I can see how they work, but I am wondeing where the bracket that would hold the rear end of the front brake cables would go? on my carryall it started under the seat area and almost hit the front of the swingarm mount before turning rearward. I know that there isn't that kinda room in a regular ds cart.

I know that I am going to have to make a bracket at work to replicate the one that was welded to the frame on the carryall.

If anybody would happen to have a picture or a diagram I would greatly appreciate any help!

thanks,
Aaron

[gcs13]

I just sent you a pm

[OLD MEC]

yOU CAN GET SPINDLES FOR FRONT BRAKES FROM CC THAT REPACES YOUR STOCK UNITS. NOT CHEAP BUT NO ALIGNMENT PROBLEMS MOUNTING BRAKES.
LEFT SPINDLE #103777401 $186.48
RIGHT SPINDLE #103777501 $188.40

[scottyb]

do you mean they do not mount on the stock DS spindle ~ I see they have to have a flange....

[4vertical]

I have the complete set up from the carryall doner cart. spindles brakes hubs drums cables and all.

the problem i see is that a carryall is a longer cart. so i couldn't figure out where to mount the bracket for the brake cables. now that i have a picture of that, i know. I am just not sure how the cables would run on a ds.

btw mine is gas i just posted here because there are probably more lsv type club cars with brakes.

interestingly the front hubs are almost the same. they just look to be a bit smaller in diameter so the drum will slide over them.

gcs13 are you anywhere near cedartown?

[gcs13]

I'm in north Ga. 50 miles north of Atlanta.