|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
05-20-2011, 10:23 PM | #11 |
Gone Wild
Join Date: Apr 2011
Location: Texas
Posts: 600
|
Re: HELP!! Key switch off but still goes FWD and RV
I downloaded the software last week and was able to connect to my 06 precedent this was 1 of the things that could be set it's free
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-21-2011, 11:58 AM | #12 |
revolutiongolfcars.com
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 10,224
|
Re: HELP!! Key switch off but still goes FWD and RV
|
05-21-2011, 12:08 PM | #13 |
Gone Wild
Join Date: Apr 2011
Location: Texas
Posts: 600
|
Re: HELP!! Key switch off but still goes FWD and RV
I will upload to my web site today will post when done
|
05-21-2011, 01:04 PM | #14 |
Gone Wild
Join Date: Apr 2011
Location: Texas
Posts: 600
|
Re: HELP!! Key switch off but still goes FWD and RV
|
05-25-2011, 02:41 PM | #15 | |
revolutiongolfcars.com
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 10,224
|
Re: HELP!! Key switch off but still goes FWD and RV
Quote:
|
|
05-25-2011, 07:45 PM | #16 |
Gone Wild
Join Date: Apr 2011
Location: Texas
Posts: 600
|
Re: HELP!! Key switch off but still goes FWD and RV
David after trying for hours to get the software to work I found my diagnostic connector rusted out guess I should Have looked up while laying on the floor.
So I cut it out and installed a earphone jack, (stereo) This is what I had used on a microcontroller project and already had DB9 to Stereo Plug harness made up. After running the program and watching the serial port, I think I will be able to make a microcontroller interface for the Curtis Controller. I think I can make a reader to monitor the state of the sensors, bat voltage controller output and much more, which would make it much easier for people to work on there units. I have done some programming of the controller using a terminal program like mode 1 through 3, this worked great, I have programmed mode 4 into the controller, it took it but the speed did not change??? guess I need code a,b and c. Now as far as connectors Were can I get the diagnostic connector both male and female if this is to much then I will use the molex connector on the Curtis controller guess I need to do some research. |
05-25-2011, 08:21 PM | #17 | |
revolutiongolfcars.com
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 10,224
|
Re: HELP!! Key switch off but still goes FWD and RV
Quote:
|
|
05-25-2011, 08:31 PM | #18 |
Gone Wild
Join Date: Apr 2011
Location: Texas
Posts: 600
|
Re: HELP!! Key switch off but still goes FWD and RV
Sorry guess I got a little over excited !!!
|
|
|
Similar Threads | ||||
Thread | Forum | |||
forward/reverse switch change to toggle switch | Electric Club Car | |||
Key switch & Kill switch question | Gas Club Car | |||
Forward Reverse switch limit switch | Electric Club Car | |||
Just got a G9 need to know how to wire ignition switch to push pull switch ASAP! | Gas Yamaha | |||
Micro switch on fwd and rev switch has bee removed | Electric EZGO |