|
07-06-2012, 09:44 PM
|
#1 |
|
Gone Wild
Join Date: Nov 2009
Location: mi
Posts: 766
|
load noise 2 stroke
my cart gas 2 stroke ezgo 91 is making an awful rattling from the motor its so load you cant talk to the person next to you and losses a ton of power barly will continue to run it actully bogged it down so bad today the lights dimmed and the cart quit waited five minutes and the cart ran so quit and smooth it was like nothing ever happend it sounds like its coming from by the flywheel and i noticed my fuel tank is getting realy warm and the fuel lines are almost hot any ideas guys would be great im thinking about pulling the motor out and seeing if the flywheel is loose
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
07-06-2012, 09:59 PM
|
#2 |
|
I Refuse To Get Stuck!!!
Join Date: Jun 2010
Location: Hilton,NY
Posts: 5,427
|
Re: load noise 2 stroke
Are you running Pre-Mix or Oil-Injection?If you are using the Oil-Injection,stop,unhook it and Mix your fuel,Its' probably leaning-out.Mix the fuel 128:1(1oz./gal.)Make sure the oil is for Pre-Mix as well,some oils now are Injection-Only.Hope this helps.
 |
|
|
|
|
07-07-2012, 07:46 AM
|
#3 |
|
Gone Wild
Join Date: Nov 2009
Location: mi
Posts: 766
|
Re: load noise 2 stroke
yes i am running premix and that was my first though that it was not enoughoil butting im mixing 1.5 per gallon with mixable oil and it is still doing it im kinda stumped its an awful noise but then goes away and the cart picks up a bumch of powere like nothing happend
|
|
|
|
|
07-07-2012, 08:51 AM
|
#4 |
|
Gone Wild
Join Date: Nov 2009
Location: mi
Posts: 766
|
Re: load noise 2 stroke
noticed this morning that carb came loose from intake this all makes alot more sense now the carb only one nut holding it on that was backed off about half way hope i didnt lean it out to the point she is limping
|
|
|
|
|
07-07-2012, 08:54 AM
|
#5 |
|
I Refuse To Get Stuck!!!
Join Date: Jun 2010
Location: Hilton,NY
Posts: 5,427
|
Re: load noise 2 stroke
Is your Primary-clutch(Engine-Mounted) screwed up?If its hanging up,then pops free and allows it to slide,it will cause power-problems.Grab the clutch,see if it rocks up/down,the bushings could be gone.Also the spring could be damaged internally,Remove the 3 cover-bolts and the center-bolt.Look it over and see if any parts are damaged/broken/excessively loose.Hope this helps.
|
|
|
|
|
07-07-2012, 09:38 PM
|
#6 |
|
Not Yet Wild
Join Date: Aug 2011
Location: buffalo ny
Posts: 42
|
Re: load noise 2 stroke
did u blow a gasket in your exhaust? this will cause it to loose power and make it a thousand times louder it just happened to mine i didnt think it would make that much of a difference but it does even the slightest leak in the exhaust will cause it to be extremely loud.
|
|
|
|
|
07-08-2012, 12:31 PM
|
#7 |
|
Gone Wild
Join Date: Nov 2009
Location: mi
Posts: 766
|
Re: load noise 2 stroke
It's defintly notorious noise but seems to have good when there is no noise as soon as it starts rattling really loud you cam barley get it to carry its own wights
|
|
|
|
|
07-08-2012, 10:24 PM
|
#8 |
|
Not Yet Wild
Join Date: Aug 2011
Location: buffalo ny
Posts: 42
|
Re: load noise 2 stroke
Do you have good compression
|
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| how to load test battery if no load tester | Electric Club Car | |||
| G9 shutting off under load | Gas Yamaha | |||
| How to check for voltage, Load or no load? | Electric EZGO | |||
| 88 ezgo 2 stroke convert to 4 stroke | Gas EZGO | |||
| can i use 2 stroke ezgo clutch on 4 stroke | Big Block Talk! | |||
Linear Mode
