98 Club Car Rear Lift

[joey klott]

I just installed a z bracket lift on front of my club car. I will post pictures of my project soon. I was wondering how to hook the brake cables up after I do the spring over lift. I put the springs on top of axle with block and put the spring plates on top. This being done theres nothing to hold the brake cable with. If any body has any pictures or any advice would be great. Thanks.

[lockman1]

Here's a few pics of what it should look like:

Note: there's a wire hanger holding the brake cable close to the frame on both sides... those need to be removed!

*EDIT* I just noticed your doing an 8" Z lift... with a just 6" lift, the cables get pretty tight to the point of no slack at all!
you may have to get longer brake cables, or an extension kit!

[joey klott]

Sweet thanks for the pictures. i actualy went with 7 inches so the cables were not that tight. i will post some pictures if i can figure out how to get them off my phone to the website. thanks again.