|
Gas Club Car Gas DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
04-12-2018, 10:44 PM | #1 |
Not Yet Wild
Join Date: Mar 2015
Posts: 14
|
Hard to start hangs up on compression stroke
I've replaced belts and starter generator and battery. It's still struggling to get past compression stroke. Belts are tight. The new battery has 550 cca. Is the enough?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-12-2018, 11:07 PM | #2 |
Gone Wild
Join Date: Mar 2012
Location: Baton Rouge, La.
Posts: 398
|
Re: Hard to start hangs up on compression stroke
Have you checked the clearance on the valves?
|
04-12-2018, 11:58 PM | #3 |
Not Yet Wild
Join Date: Mar 2015
Posts: 14
|
Re: Hard to start hangs up on compression stroke
No I have not adjusted the valves. I wouldn't know how too. If that's the problem I will have to take it to a shop. If i manually rotate the wheel back away from the compression stroke resistance and it has momentum when it hits it.... it starts right up
|
04-13-2018, 06:35 AM | #4 |
Gone Wild
Join Date: Dec 2017
Location: Portsmouth, VA
Posts: 626
|
Re: Hard to start hangs up on compression stroke
dont think it should need a running start
is the battery fully charged and holding a charge ?? if the valves are out of adjustment then may be too tight ?! |
04-13-2018, 07:33 AM | #5 |
Gone Wild
Join Date: Jun 2015
Location: NW Iowa
Posts: 1,669
|
Re: Hard to start hangs up on compression stroke
I highly doubt valves are your issue here... Check and clean all battery connections on battery and all on the starter generator was this happening before the new srtarter generator was added?
|
04-13-2018, 07:57 AM | #6 |
Gone Wild
Join Date: Sep 2015
Location: New Braunfels, TX
Posts: 178
|
Re: Hard to start hangs up on compression stroke
If it's an fe350 valves are not the source of the problem
|
04-13-2018, 08:01 AM | #7 |
Gone Wild
Join Date: Mar 2015
Location: Central mn
Posts: 1,036
|
Re: Hard to start hangs up on compression stroke
Is it a club car starter? Or fleabay?
If it is a good starter I would go with the other suggestions of corroded, bad, loose connections. |
04-13-2018, 11:45 AM | #8 |
Not Yet Wild
Join Date: Mar 2015
Posts: 14
|
Re: Hard to start hangs up on compression stroke
After inspecting the wires to the starter... they dont look good. Im going to replace them and report back
|
04-14-2018, 06:26 AM | #9 |
Getting Wild
Join Date: Jan 2018
Posts: 88
|
Re: Hard to start hangs up on compression stroke
Is your cart a pedal-start -or- a retro-keystart vehicle?
|
04-15-2018, 11:10 PM | #10 |
Not Yet Wild
Join Date: Mar 2015
Posts: 14
|
Re: Hard to start hangs up on compression stroke
After cleaning all connections and retightening the belt.... it's starting better than before. However it still hesitates when it's cold (been sitting ) I can live with it now.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
wont start on compression stroke | Gas EZGO | |||
86 Ezgo stroke low compression | Gas EZGO | |||
1988 2 Stroke No Start, low compression-please advise | Gas EZGO | |||
How to check compression on a 2 stroke | Gas EZGO | |||
86 2 stroke hard to start(has to be full throttle) | Gas EZGO |