3 position key switch

[lugster]

97 DCS TXT 36 volt. The original 2 spade key switch has a yellow wire and a white wire with a yellow stripe. Wiring up the new key switch, 36 V + has to go to the B spade. My hunch is it is the white wire with yellow stripe, any one know for sure. I saw many diagrams and just want to be sure.

[scottyb]

See DCS diagram attached. The white with yellow strip is the wire that goes to B (aka battery) it should have battery voltage each time, every time the pedal is depressed

[JohnnieB]

Here's a schematic with readable wire color.

[lugster]

Thanks to you both!!

[lugster]

Just to make sure this is the wiring how I see it, 3 way EZGO key switch with Scotty's DVM, yellow and white wire with yellow stripe originally went to stock 2 position key switch.

White wire with yellow stripe from controller to B on the key switch.

Run a Hot wire from the battery Pack + and the RED wire from the meter to I on the key switch.

Yellow from controller and a wire directly from the battery pack - to the black wire on the meter. Sound about right?? I assume the 12v reducer goes to B1 + and L -.