|
Design Center Shop tools, fabrication and Paint and Body |
|
Thread Tools | Display Modes |
02-14-2008, 12:49 PM | #1 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,417
|
where to mount controller?
guys, I am converting an 89CC to controller. Per Nates suggestion I am going to mount the PB-6 as high up in the battery compartment as possible. This is for H2O protection. Which means it will end up right under the drivers side of the seat. Can I put a splash shield under it or is heat a consideration? Where will I find a 90* linkage body to do this?
And 2nd - where would you suggest I mount the controller? It looks to be about 6 x 8 inches? Thanks for any and all input? |
|
|
Similar Threads | ||||
Thread | Forum | |||
Where does it mount, Controller and OBC | Electric Club Car | |||
G9 motor mount | Design Center | |||
G-9 engine mount | Design Center | |||
yamaha tie rod mount | Gas Yamaha | |||
g9 vanguard mount | Gas Yamaha |