|
|
|||||||
| Electric Club Car Electric DS, and Precedent golf cars |
  |
|
|
Thread Tools | Display Modes |
09-04-2015, 10:42 AM
|
#1 |
|
Not Yet Wild
Join Date: Jan 2012
Location: tx
Posts: 8
|
94 36v club no power to solenoid trigger.
I have a 36v club car ds. I replaced the solenoid with a cheap one. It lasted 2 days. I put another cheap one on. And it wouldn't run. (I had ordered 2 at the same time). I started testing wires. Well the wire on the small post on the solenoid isn't getting power to activate the solenoid. So I go back to the f/r switch. I notice one of my microswitch is broke. So I ordered 3 new ones and replaced them. Still not getting any power to or from the microswitches. Well the reverse one has power the other 2 dont. Any ideas? I have not replaced the microswitch in the V glide.
Also what is the correct direction to wire the diode and resister on the solenoid? Or does it even matter? Thanks |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
09-04-2015, 10:52 AM
|
#2 |
|
Guest
Posts: n/a
|
Re: 94 36v club no power to solenoid trigger.
check key switch
yes you need to wire diode like diagram  |
|
|
|
09-04-2015, 10:58 AM
|
#3 |
|
Not Yet Wild
Join Date: Jan 2012
Location: tx
Posts: 8
|
Re: 94 36v club no power to solenoid trigger.
Thanks for the diagram. I did check the key switch and it looked fine. I also just jumped the key wires together and did not make a difference. I think I probably wired the diode backwards on the 2nd solenoid. What would short or happen if I did? Thanks.
|
|
|
|
|
09-04-2015, 11:04 AM
|
#4 | |
|
Guest
Posts: n/a
|
Re: 94 36v club no power to solenoid trigger.
Quote:
 |
|
|
|
|
09-04-2015, 11:18 AM
|
#5 |
|
Not Yet Wild
Join Date: Jan 2012
Location: tx
Posts: 8
|
Re: 94 36v club no power to solenoid trigger.
Sorry for the confusion. I meant on the 2nd solenoid I replaced.
|
|
|
|
|
09-04-2015, 11:27 AM
|
#6 |
|
Happy Carting
 Join Date: Dec 2007
Location: Southern California
Posts: 73,406
|
Re: 94 36v club no power to solenoid trigger.
Diode installed backwards? ...very likely the microswitch in the V glide has burnt like a fuse.
|
|
|
|
|
09-05-2015, 07:03 PM
|
#7 |
|
Not Yet Wild
Join Date: Jan 2012
Location: tx
Posts: 8
|
Re: 94 36v club no power to solenoid trigger.
yup the micro switch in the V glide was fried. Plus I tested the Diode it is bad too. So I am going to order a new diode, a new resister, and a new micro switch. Hopefully that will take care of my issues
|
|
|
|
|
09-05-2015, 07:52 PM
|
#8 |
|
Guest
Posts: n/a
|
Re: 94 36v club no power to solenoid trigger.
 |
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Pulling the trigger on new vs used | Gas Club Car | |||
| pulled the trigger today | Clone Engine Swaps | |||
| club car 48 volt no power to solenoid | Electric Club Car | |||
| 49 volt club car no power to solenoid | Electric Club Car | |||
| Almost ready to pull the trigger on the BB | Big Block Talk! | |||
Linear Mode
