|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
04-23-2021, 01:38 PM
|
#1 |
|
Not Yet Wild
Join Date: Apr 2021
Location: Louisiana
Posts: 7
|
Motor Resistance Checks help
Troubleshooting 2006 EZGO PDS no go. Made resistance checks on stock motor according to the Curtis 1206MX install sheet, with motor completely disconnected at the controller. All measurements were within spec except for F1-Motor case. This measures open when probes are connected one way, and 2.050Megohm when probes are switched, as if measuring through a diode. The install sheet does not mention this. It merely states that this measurement must be greater than 5Megohm. So, question is, would you consider this motor bad given the above F1-Case measurement?
 |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
04-23-2021, 03:08 PM
|
#2 |
|
Techno-Nerd
 Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Motor Resistance Checks help
If there is some rust present, you can get a rectifier effect. (Iron oxide rectifier stack of yesteryear.
 )The less than 5MΩ reading indicates a buildup of carbon dust from brush wear. A good cleaning, a new set of brushes and maybe a new bearing is probably all that motor needs. |
|
|
|
|
04-23-2021, 03:28 PM
|
#3 |
|
Not Yet Wild
Join Date: Apr 2021
Location: Louisiana
Posts: 7
|
Re: Motor Resistance Checks help
Thanks, JohnnieB. Like your tag line...
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 2011 Precedent OBC checks out but still does not operate | Electric Club Car | |||
| Annual Maintenance Checks and Services | Electric EZGO | |||
| Voltage Checks on EZGO | Electric EZGO | |||
| 1999 48 volt club car solinoid checks | Electric Club Car | |||
| verbo checks in | Design Center | |||
Linear Mode
