|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
02-16-2013, 05:12 AM
|
#1 |
|
Not Yet Wild
Join Date: Feb 2013
Posts: 3
|
g16a stopping problems
hi i have a g16a that has had the clutch replaced and pistons and rings done and had a fuel pump replaced
the cart runs fine for roughly 6 holes then stops,the engine still turns over slowly and the cart moves very slow if at all,occasionally the cart smells of fuel and the carby has also been cleaned please help this driving me crazy thanks in advance |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
02-16-2013, 08:49 AM
|
#2 |
|
Getting Wild
Join Date: Sep 2012
Location: INDY
Posts: 125
|
Re: g16a stopping problems
Did you have the carbs cleaned by someone or yourself, you may want to open it back up and check it out, float sticking! Did the cart set for a while, drain old fuel?
|
|
|
|
|
02-16-2013, 08:59 AM
|
#3 |
|
Not your usual outlaw
 Join Date: Oct 2008
Location: Near Lake Geneva, WI
Posts: 20,054
|
Re: g16a stopping problems
Replace the spark plug
 |
|
|
|
|
02-16-2013, 10:37 AM
|
#4 | |
|
Sometime's............
Join Date: Oct 2007
Location: Tacoma Washington
Posts: 11,874
|
Re: g16a stopping problems
Quote:
I have seen the TCI unit fail after getting warm/run time, then cools down and sparks again. |
|
|
|
|
|
02-16-2013, 04:30 PM
|
#5 |
|
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,443
|
Re: g16a stopping problems
Not seen it on this cart but common for TCI and ignition pickups to fail with heat. Check the spark when it does this then you would know. BPR2 is the plug to use for sure. You can get a spark checker that goes on the wire for like $5 at autozone/etc.
|
|
|
|
|
02-18-2013, 06:25 AM
|
#6 |
|
Not Yet Wild
Join Date: Feb 2013
Posts: 3
|
Re: g16a stopping problems
hi guys thanks for the advice,i changed the plug and the plug was really dirty i then drove the cart for 6 holes and the same thing as before it stopped and would not go.when it did start back up 5 mins or so i got it back and pulled out the plug and the new plug was also dirty any ideas thanks again
|
|
|
|
|
02-18-2013, 08:17 PM
|
#7 |
|
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,443
|
Re: g16a stopping problems
Do these ever plug the muffler? I've not heard much on 4 strokes doing that. Dirty plug would mean burning oil or poor mixture such as running rich.
|
|
|
|
|
02-20-2013, 01:13 AM
|
#8 |
|
Not Yet Wild
Join Date: Feb 2013
Posts: 3
|
Re: g16a stopping problems
thanks the cart is not burning any oil has anyone got some ideas of anything else it could be cheers
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 06 PDS stopping cart | Electric EZGO | |||
| Not Stopping | Gas Club Car | |||
| G16A secondary clutch removal problems | Gas Yamaha | |||
| Stopping the charge? | Electric EZGO | |||
| 96 G16A starting problems | Gas Yamaha | |||
Linear Mode
