|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
03-03-2013, 10:52 PM
|
#11 |
|
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: G2 front shocks
It runs good on the ground. I'll be putting it back in the cart next weekend. I'm hoping it is making 100hp!
 |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
03-03-2013, 10:53 PM
|
#12 |
|
G8 Specialist
Join Date: Jun 2009
Location: Phoenix
Posts: 7,799
|
Re: G2 front shocks
Holly Cow! For real?? You'll be doin 8's in the quarter!!!
|
|
|
|
|
03-03-2013, 10:57 PM
|
#13 |
|
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: G2 front shocks
I wish... I'm not sure what to expect from the 16hp Vanny. I would think 20hp isn't out of the question. I built it for added low end torque, and the ability to rev it without twisting things up. Should be good for over 6k rpm.
|
|
|
|
|
03-03-2013, 11:10 PM
|
#14 |
|
G8 Specialist
Join Date: Jun 2009
Location: Phoenix
Posts: 7,799
|
Re: G2 front shocks
Good for you Man!! That might make close to 50 MPH!!?? More than enough!! Wish I could afford one!
Good Luck!! Mike I noticed (upstate NY) might get with Tommy, in Dansville, (G1-G9) in "The G8 Club"! Nice guy, but don't tell him I said so! |
|
|
|
|
03-04-2013, 11:53 AM
|
#15 |
|
Getting Wild
 Join Date: Oct 2009
Location: Nevada City, Ca
Posts: 146
|
Re: G2 front shocks
Thanks Mike I'm going to try it now mainly because Marathon insulted my integrity.....just kidding
|
|
|
|
|
03-04-2013, 12:00 PM
|
#16 |
|
G8 Specialist
Join Date: Jun 2009
Location: Phoenix
Posts: 7,799
|
Re: G2 front shocks
There ya go Dude! Yea got it!!
 And it looks great!! Nice work!Now start workin in the smily guys!!    |
|
|
|
|
03-06-2013, 09:39 PM
|
#17 | |
|
Not Yet Wild
Join Date: Dec 2012
Location: Kentucky
Posts: 42
|
Re: G2 front shocks
Quote:
the upper part (yoke?). After depressing the spring, you will gain access to a 14mm nut. Use end wrench through spring coils to hold nut. Turn upper piece while holding wrench. Lock tight was used during assembly, it may help to warm it up a bit. Don't forget to re-lock tight. Trent |
|
|
|
|
|
03-06-2013, 09:56 PM
|
#18 |
|
G8 Specialist
Join Date: Jun 2009
Location: Phoenix
Posts: 7,799
|
Re: G2 front shocks
Guess I should show you what I did! Split shaft collar.
|
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Replacing Front Shocks w/o Front Cowl Removal | Electric EZGO | |||
| G16 Shocks-Front end | Gas Yamaha | |||
| Front shocks for g16 | Gas Yamaha | |||
| NEW front shocks | Members Rides | |||
| Bad front shocks? | Gas Yamaha | |||
Linear Mode
