|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
08-06-2013, 10:29 PM | #1 |
Not Yet Wild
Join Date: Jul 2009
Posts: 10
|
Install hidden toggle switch
Hello, on a "97" gasoline Yamaha golf cart .... since 1 key fits all... what color wire/location, do you splice a hidden toggle switch to prevent theft. In my younger days, used to splice the hot lead to the starter. But, baffled with the golf car circuity. thanks much for your time
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-07-2013, 05:59 AM | #2 |
Not Yet Wild
Join Date: Jun 2013
Location: SE PA
Posts: 58
|
Re: Install hidden toggle switch
At least on my 2000 G16...there's a plug behind the key switch. One in...one out. You'd have to trace it back.
Or...replace the ignition switch. That's what I did on mine. There are all kinds of switches with one or two positions. (You don't need the twist to start position) Check eBay...lots of different choices. Some are made for motorcycles. Or, I think NAPA sells them too. |
08-07-2013, 07:54 AM | #3 |
G8 Specialist
Join Date: Jun 2009
Location: Phoenix
Posts: 7,799
|
Re: Install hidden toggle switch
Just pull the fuse if you leave the car in situation like that. My car is street legal, I drive and leave mine all the time. Never had a problem. And a dirty little secret, you don't need a key to start mine, a paper clip or popsicle stick will start it.
|
08-07-2013, 01:48 PM | #4 |
Not Yet Wild
Join Date: Jul 2009
Posts: 10
|
Re: Install hidden toggle switch
thanks for the reply.....
|
08-07-2013, 06:33 PM | #5 |
Sometime's............
Join Date: Oct 2007
Location: Tacoma Washington
Posts: 11,875
|
Re: Install hidden toggle switch
A great place for a toggle kill switch is the plastic cover that cover's the solenoid/fuse/voltage regulator and engine relay, just to the right of the battery. There is a red wire with "snap" connectors, extend the wires to a high quality on/off toggle switch and mount it on the drivers side of the cover. You can reach in and "flip it" and no one can see it's there
|
08-07-2013, 09:42 PM | #6 |
Not Yet Wild
Join Date: Jul 2009
Posts: 10
|
Re: Install hidden toggle switch
thanks much for your reply
|
|
|
Similar Threads | ||||
Thread | Forum | |||
forward/reverse switch change to toggle switch | Electric Club Car | |||
Hidden on/off switch - any suggestions where? | Electric EZGO | |||
2009 Precedent run/tow toggle switch replaced with keyed switch | Electric Club Car | |||
Headlights will not come on, but toggle switch is lit up? | Electric Club Car |