96 ezgo golf cart.

[wthyaya]

the golf cart starts up. but when i push the gas it goes no where. it just revs up. i heard this could be the dcs controler or solenoid. plsssss help thank you.
no smoking or nocking, just a little tick when i accelerart going no where.

also there is a belt that just hangs loos around the rear axel up to the motor is this normal?
thank you for your time.

[kgsc]

Is this a gas cart ?? Posted in the Electric section ?? If gas, there should be two belts. One that is 1/2 inch wide that goes from the starter generator to the rear pulley on the drive clutch mounted to the engine crankshaft. The other belt is roughly 1 1/2 inches wide and goes from the Front drive clutch to the rear driven clutch. Which one isn't where it is supposed to be ?

[wthyaya]

yes, it is a gas, i apoligize im new on this site and i have not figured it out. yes there are two belt. the thicker belt is just loose. looks completly like kits the wrong size belt. it ran before and now it starts but doesnt move. it just revs up when i push the accelerator .

[wthyaya]

is there a solenoid or sencor that could of gone out to make it not responsive when i push the gas pedal?

[rib33024]

Moved To Gas

[kgsc]

Are both clutches spinning? If so, transmission or shift linkage, if not, belt.

[guntruck]

Originally Posted by wthyaya

yes, it is a gas, i apoligize im new on this site and i have not figured it out. yes there are two belt. the thicker belt is just loose. looks completly like kits the wrong size belt. it ran before and now it starts but doesnt move. it just revs up when i push the accelerator .

Can you take a pic of the engine compartment and post a pic?

[kgsc]

The larger belt will be loose until the clutch engages. Slide the belt off the rear pulley and see if you can push the front clutch towards the motor. If it doesn't jive your front clutch needs attention.