|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
05-06-2013, 09:58 PM | #11 | |
Gone Wild
Join Date: Jul 2012
Location: Central FL
Posts: 1,195
|
Quote:
Really appreciate the DIY cable link, love doing my own stuff so ill definitely be checking it out to see if it makes cents - pun intended :P ...One avenue I haven't yet pursued is I heard welding shops will crimp for free if you buy the wire from them. Also heard NAPA auto parts will do the same. Again, I don't know the cost involved, but it would save me the price of buying a crimper! Thanks again! Sent via TapaTalk |
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-07-2013, 08:04 AM | #12 |
Not Yet Wild
Join Date: Jan 2012
Posts: 39
|
Re: Cable length of a Resistor DS?
The motor at anything other than WOT isn't drawing full power. Whats happening when you are stepping through the throttle is 4 different resistors are limiting the voltage available to the motor. VOLTAGE controls the SPEED> CURRENT controls the TORQUE.
At lower speed you current consumption by the motor is less. I don't know if DC motors have linear current consumption or not, I am an electronics guy, not a electrical guy. If they are linear that would mean at 25% speed it draws 25% as much current as 100% and 50% draws 50%. It really doesn't matter that much. I am going to upgrade the cables on one of my resistor carts this weekend and see what it does performance wise. I am going to run 2 gauge on the direct link, F/R switch, to the step box, and solenoid, and 4 gauge on everything else. It would have to make a small difference on the last throttle position, but the limiting factor is going to be the solenoid and stepper switch current capability. |
05-07-2013, 08:08 AM | #13 | |
Gone Wild
Join Date: Nov 2010
Location: Lower SE Michigan
Posts: 330
|
Re: Cable length of a Resistor DS?
UncleJerm said:
Quote:
You've been taught wrong. During my electronics schooling (Associate's Degree), our instructor asked the trick question, "When your car's heater blower is on 'low', the current goes through a resistor to make it run slower. As the excess voltage is disappated in the form of heat, does the current draw from the battery remain the same?" Your answer would have been 'Yes', but of course that is wrong. Going back to basics, think of the motor as a resistor: going by Ohm's Law, given a certain battery voltage, it will draw XX amps. Add a resistor in series (those 'old school' coils) and the total circuit resistance is higher, thus the total current draw is less. Yes, you are wasting some battery energy and a solid-state controller will be more efficient overall, but it isn't as much as many people think. What you're picturing is a shunt (instead of series) resistor coil, which would be the equivilant of riding the brakes to control the speed, something that would obviously hurt efficiency. |
|
05-07-2013, 09:07 AM | #14 | |
Gone Wild
Join Date: Jul 2012
Location: Central FL
Posts: 1,195
|
Quote:
Sent via TapaTalk |
|
05-07-2013, 09:08 AM | #15 |
Gone Wild
Join Date: Jul 2012
Location: Central FL
Posts: 1,195
|
|
05-08-2013, 12:58 PM | #16 |
Gone Wild
Join Date: Jul 2012
Location: Central FL
Posts: 1,195
|
Re: Cable length of a Resistor DS?
I have the DS VGlide with one solenoid. I highlighted all the wires I think I need in this diagram for full throttle only, did I get them all? Battery Wires will be ordered too but I excluded those in the diagram. Oh and if you see a mistake of one I don't need or one I left out, please refer to the wire number so I can find it easily. As it is below I think I need eight wires? ( 1, 2, 3, 4, 5, 12, 21, 23 )
|
05-08-2013, 01:53 PM | #17 |
Not Yet Wild
Join Date: Jan 2012
Posts: 39
|
Re: Cable length of a Resistor DS?
You would also need the short cable from the wiper on the vglide to the solenoid
|
05-08-2013, 01:58 PM | #18 | |
Gone Wild
Join Date: Jul 2012
Location: Central FL
Posts: 1,195
|
Re: Cable length of a Resistor DS?
Quote:
...Ugh never mind. I see now that is the one wire that is not upgradable. I have a bad feeling if I upgrade the rest of them that will be the weakest link and will probably fail the first time the cart is under extreme load ie: Slowly going up a steep incline. Looks like I'm stuck with buying new 6ga. Wish I had an extra 1k laying around to do the SSD upgrade. |
|
09-05-2013, 03:19 PM | #19 |
Gone Wild
Join Date: Jul 2012
Location: Central FL
Posts: 1,195
|
Re: Cable length of a Resistor DS?
Hey MSDeer was hoping you could provide some followup on how your replacements went? I did my battery pack after a old terminal overheated and broke. Then the cable from my solenoid to F/R switch melted in half at the terminal. Slowly replacing them all with 2 ga. Any feedback on how your little project went?
|
09-05-2013, 03:44 PM | #20 |
Gone Wild
Join Date: Jun 2013
Location: San Clemente, CA
Posts: 259
|
Re: Cable length of a Resistor DS?
Might want to also check this out.
http://www.buggiesunlimited.com/golf...e%20bypass.pdf 4 and 2 gauge lugs don't really fit into the V Glide very well. Will need some modification. Additionally, the wiper arm (the real problem) is only 6 gauge, with no way to upgrade it. You can do new wires for the batts, the FnR and solenoid. Cut and crimp your own cables with a (hammer) crimper, lugs and cable. You can even make your own V Glide cables with modified lugs. Wiper arm is the way it is. If memory serves, I used approx. 35 feet to do all but the V Glide. Keep the wires as short as possible, if you can. Upgrading will lessen the resistance through all the upgraded cables = less heat, means they stay cooler. |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
cable length and where used diagram? | Electric EZGO | |||
Cable length question? | Electric Club Car | |||
4ga Cable Length?? | Extreme DC! | |||
Cable length | Electric Club Car | |||
Cable Length - Do-It-Yourself Cables | Electric Club Car |