ezgo txt shock tabs.

[deerhunter88]

I had time to pull out a tape and take some measurements yesterday. Both shock tabs are exactly 22"s from the ground (lowest point center of tab). I did influence the left tab (the one that was in question) some to get it to the 22" mark. She was closer to 21 5/8" Front axle is exactly 16"s left, right, and center....I didn't measure anything on the body of the cart. Will wait until I get the new shocks in for that.

[deerhunter88]

So I put the HD Coil Shocks on the front of the cart. Didn't really bend any of the tabs. Just the left one a tiny bit and didn't touch the right one. It came out close to level so that did the trick. But now I have a different problem. The front is now higher than the back!! Do you think putting a set of HD coil overs one the back will lift the back some?? Cart already has HD leaf springs. Any help is appreciated. Does a 2007 ezgo txt use the same spring for front and rear are they sized different?

[pachanga90]

The front and rear springs are completely different in design.The coil-overs may help the rear,it depends on the installed length.If they are heavy enough and tall enough,they may compensate for the difference.Keep in mind,you already have the HD rear-springs,so it may not come up.How much weight is on the rear(seat,dump-box,etc...),or is it bare?That will also affect the height.Hope this helps.

[deerhunter88]

Cart has the rear seat.