|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
03-25-2013, 11:53 AM | #1 |
Not Yet Wild
Join Date: Mar 2013
Posts: 1
|
speed control wiring
I have a 36 volt ez-go date code L0906, serial # 2435565. The wiring to the speed control melted. I replaced the speed control. I need to know which color wire connects to which terminal on the control. The connector was fried so I need to connect them individually.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-25-2013, 12:57 PM | #2 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,410
|
Re: speed control wiring
If the Molex 5 pin connector has melted you can connect to an Alltrax AXE or SPM control via the spade connectors.
#1 = red #2 = Black #3 = white #4 = orange #5 line up pin not used NPX controls differ ... See my controller install sheet below |
|
|
Similar Threads | ||||
Thread | Forum | |||
Speed control | Electric EZGO | |||
solenoid and speed control module wiring | Electric EZGO | |||
speed control? | Electric EZGO | |||
more speed without sacrificing low speed control | Gas Club Car | |||
Speed control | Electric EZGO |