|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
10-20-2020, 06:18 PM
|
#1 |
|
Getting Wild
Join Date: Sep 2015
Location: West Virginia
Posts: 100
|
Anyone done a Governor delete Yamaha g16
Reason I知 asking is I traded for a g16 I have to replace the input shaft but someone has cut the governor shaft off next to the case should I remove the weights on the input shaft or should everything work ok without removing them thanks
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
10-20-2020, 07:23 PM
|
#2 |
|
Searching for The Way
 Join Date: Oct 2009
Location: Medina, Ohio (NEOHIO)
Posts: 11,745
|
Re: Anyone done a Governor delete Yamaha g16
It's up to you. If you drive fast a lot, remove it. If you mostly take it easy, it should be ok. But if you're opening up the transaxle to replace the input shaft, that's the time to do it.
 |
|
|
|
|
10-20-2020, 07:57 PM
|
#3 |
|
Getting Wild
Join Date: Sep 2015
Location: West Virginia
Posts: 100
|
Re: Anyone done a Governor delete Yamaha g16
Thanks I知 up In the air I hate to start taking stuff off a new Input shaft
|
|
|
|
|
11-01-2020, 08:05 AM
|
#4 |
|
maintaining a low profile
Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,363
|
Re: Anyone done a Governor delete Yamaha g16
When I replaced my input shaft in my Vanguard cart, it was all new to me. The new shaft was installed with all OEM governor parts. It's never been a problem. If I did it again, I'd probably remove the weights from shaft and eliminate the governor arm.
On a stock engine cart, I'd leave everything as is. The governor arm and bushings can be drilled out so they rotate freely on the gov arm shaft. |
|
|
|
|
11-01-2020, 07:22 PM
|
#5 |
|
Getting Wild
Join Date: Sep 2015
Location: West Virginia
Posts: 100
|
Re: Anyone done a Governor delete Yamaha g16
I知 putting a 420 in it so I値l probably remove the weights thanks for the replies
|
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Yamaha g8 governor help please | Gas Yamaha | |||
| Ydr g29 governor delete | Gas Yamaha | |||
| Robin 350 governor delete ??s | Gas EZGO | |||
| Yamaha G1 rear end governer delete | Gas Yamaha | |||
| ISO: Yamaha G1 governor | Golf Carts and Parts | |||
Linear Mode
