![]() |
![]() |
#1 |
Not Yet Wild
Join Date: Aug 2011
Posts: 27
|
![]() What exactly does the one needle adjustment do on the carb of the KF82? My cart is "hard starting" but once warmed up for a while, it will run fine...does this adjustment have anything to do with that? I really have to choke and choke it and it will take off then sputter and i'll choke it again then once ran for a while it runs/starts fine..
any ideas? Chad |
![]() |
![]() |
![]() |
|
![]() __________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
![]() |
#2 |
The Last Moja Morani
![]() ![]() Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
|
![]() you would be better off taking the carb off and really going over it.......................
![]() |
![]() |
![]() |
![]() |
#3 |
Not Yet Wild
Join Date: Aug 2011
Posts: 27
|
![]() carb has been totally broken down, soaked, blown etc...im just wondering what that screw acutally does....
|
![]() |
![]() |
![]() |
#4 |
The Last Moja Morani
![]() ![]() Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
|
![]() its air/fuel mixure.....when you tore carb down did you take every jet out and run a wire thur every hole you could find? did you use a compressor to blow thur every opening and port you could find?..............................
![]() |
![]() |
![]() |
![]() |
#5 |
Not Yet Wild
Join Date: Dec 2011
Posts: 16
|
![]() I think hes talking about the screw on top of carb that looks like a jet. Sorry I dont know why its there hopefully someone can answer that
|
![]() |
![]() |
![]() |
#6 |
The Last Moja Morani
![]() ![]() Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
|
![]() it has somethijng to do with air.....has to be in and tight, they tend to work out and if it does cart will run but like crap if you take just a common screw that fits and put it in cart will run great............................
![]() |
![]() |
![]() |
![]() |
#7 |
Gone Wild
![]() ![]() Join Date: Jul 2008
Location: Reddick IL
Posts: 11,278
|
![]() That is the idle air jet it meters the air to the emulsifier? tube,
the one with all the little holes in it. Often people look in the emulsifier and can see through it and think it is clean but it will still have gum on the sides and make starting and idling hard. |
![]() |
![]() |
![]() |
|
Thread Tools | |
Display Modes | |
|
![]() |
||||
Thread | Forum | |||
kf82 valve adjustment | Gas Club Car | |||
KF82 Carb fuel line fitting problem | Gas Club Car | |||
KF82 flathead carb spacer | Gas Club Car | |||
KF82 Carb. rebuild kit | Gas Club Car | |||
kf82 carb | Gas Club Car |