96 cc keeps running.

[Pinky48]

When i shut off my engine it spits and sputters till it finelly shuts off. Could it be this ethenoel in the gas? I add lucas to the gas.

[yamahag9er]

I would check the butterfly in your carb and make sure that it is closing completely. I don't know about the fuel. I guess it could be an issue as well.

[Pinky48]

Thanks Yamahag9er

[jace1975]

Is your cart a pedal start? If it is, and you say it keeps running, then it sounds like you have a limit switch not working/not set right. I would be checking the limit switches in the black box.

Jason

[Dave Box]

You need to check your engine first, throttle switch, carburetor settings and make sure that you have the correct spark plug. If all that checks out then you have to check why you have a source of ignition with the engine off. This could well be carbon build up or a damaged piston as this article states
http://www.popularmechanics.com/home...nd-tear-of-e10
I only buy my gas from a small mini mart that proudly advertises "NO ETHANOL"

Dave

[yamahag9er]

It could be the limit switches. Either one is bad or out of adjustment. Accel pedal linkage could be out of adjustment. We had a cart in the shop about a week ago with basically the same problem. I checked all of the switches and even replaced them and no luck. Come to find out after I pulled the black plastic cover off of the carb I noticed that it wasn't adjusted properly and the butterfly wasn't closed completely. Adjusted that and no more problems.

[rose88]

Check cable going into black box, make sure you can only see about a 1/4" of

threads outside the box. Could be adjusted too tight and will not shut

off?

[Pinky48]

Thanks Guys! I unpluged the limit switch and now its do fine. Now i have to buy new one or get a tach. Thanks for all your help!

[jace1975]

I have some left from my cart if they will work you can have them. 2 of them are new/barely used. My cart is an 88 CC. Maybe one of the guys on here know if they are the same on our 2 carts.

Jason

[invalidsession]

Originally Posted by jace1975

I have some left from my cart if they will work you can have them. 2 of them are new/barely used. My cart is an 88 CC. Maybe one of the guys on here know if they are the same on our 2 carts.

Jason

They are the same, NO / NC. The three post micro can be used in either location by substituting the post positions to suit. No need to buy separate switches, just buy the three pole part and wire as required. $1.99 each + $1.00 shipping from my source. Damned if I'll pay through the nose for these commonly available parts. It's ridiculous what some companies mark these things up at.

Chris.