|
Design Center Shop tools, fabrication and Paint and Body |
|
Thread Tools | Display Modes |
03-10-2009, 04:25 PM | #1 |
Not Yet Wild
Join Date: Mar 2009
Posts: 3
|
Gearbox Information Required
Hi All,
Hope this is in the right forum. I built a trike for the road using a 4-Stroke Ez-Go Rear axle and Gear box. I modified the gearbox for a higher ratio and more speed. I'm up to about 50 miles an hour now but my 140cc engine is screaming and I know I can get a lot more from it. The problem I have is I made a Sprocket Carrier from the slipper clutch wheel on the gearbox but I can only get down to a 22 Tooth sprocket I would like to go down to a 16 tooth. I can get a friend of mine to waterjet a new splined center for me if I have a cad file of even an accurate drawing of the shaft. I'm useless with CAD and wondered if anyone would have the shaft dimensions on file. I hope the pictures below help. Cheers, Aidan. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-10-2009, 04:30 PM | #2 |
****tard supreme
Join Date: Jun 2008
Location: waldo,wisconsin
Posts: 5,401
|
Re: Gearbox Information Required
what about going to a larger rear wheel/tire
just my two cents |
|
|
Similar Threads | ||||
Thread | Forum | |||
G-9 belt information | Gas Yamaha | |||
Looking for good Information | Electric golf carts | |||
Good information | Electric Club Car | |||
Information on a 1984 Club Car | Electric Club Car | |||
Information Links | Gas EZGO |