Hot A2 wire after motor upgrade

jjance · 10-10-2016, 10:39 AM

From post #14

Quote:

make sure you can find a connector that will fit the connection on the controller

Quote:

why does my 500 amp controller not call for replacement of these wires

Don't know. But if you have 5/16" connectors on both the controller and your motor why shouldn't you use a wire sized to the bolt size. There are references for this. I'll try to look them up and get back to you.

teecro · 10-10-2016, 11:56 AM

Don't go out of your way I see that you did address an unnessasery and impractial suggestion by leaving it up to the OP to find a connector that will be rare to find at best....

And the connection for F1/F2 on my controller was 1/4" or 6 mm ( Not sure from here.) and FSIP directions stated to cut off the ends and replace as needed.

10-10-2016, 11:56 AM	#22
teecro Gone Wild Join Date: Jun 2014 Location: Sunset Bay, TN Posts: 2,390	Re: Hot A2 wire after motor upgrade Don't go out of your way I see that you did address an unnessasery and impractial suggestion by leaving it up to the OP to find a connector that will be rare to find at best.... And the connection for F1/F2 on my controller was 1/4" or 6 mm ( Not sure from here.) and FSIP directions stated to cut off the ends and replace as needed.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Forum
considering 4ga wire upgrade?	Electric Club Car
1/0 wire upgrade	Electric EZGO
Wire upgrade?	Electric EZGO
EZ GO DCS Wire Upgrade	Electric EZGO
No Reverse after wire upgrade	Electric EZGO

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum