82 Club car only runs at full speed

[OLD MEC]

With above ( correct wiring diagram ) you might want to double check which F&R switch you have as there are some differences in wiring based on which F&R switch you have?

[jawekr73]

Thanks but i saw that one, but you cant read the motor terminal post numbers and my motors posts are arranged diffrent, not in a straight line like in the drawing

[OLD MEC]

"Most Motors" have letters stamped on housing beside posts that will give you needed info? It may be stamped very light so clean area and look closely.

[jawekr73]

Yes i see a1 , a2 , s1 , s2 but what i need is which wires connect to the which number

[OLD MEC]

Its been a long time and also depending on which F&R switch you are using, BUT this is what I remember??? I could be all wrong so BEWARE and I would wait for confirmation of some one else to see if my wiring is correct? SCOTTYB HELP am I right??

A-1= Wire from Right Rear of F&R swivel plate ( Passenger side )
A-2= Wire from Passenger side of resistor board
S-1= F&R lower posts ( jumpered together on later switches )
S-2= Number 6 battery negative terminal ( back one behind drivers seat )

[jawekr73]

No luck, it made the reverse buzzer come on in forward and reverse

[scottyb]

This will work for 5 solenoid and resistor carts.....

[jawekr73]

Img_0004.jpg
img_0005.jpg
img_0006.jpg
img_0007.jpg

[jawekr73]

Finally got it guys, my f&r was diffrent so i changed the wires and it works now. One last question, i just took it around the neighborhood and after checked all connections for heat and the only thing hot was the coils, i assume thats normal with a resistor and assume its from the low speed solenoids?

[jawekr73]

Thanks again guys , i really appreciate the help !!!!!!