Micro Switches Keep Blowing

[bobsaladbar]

I checked the glide box to make sure blue wire was on common (bottom) & green wire on top. The tape is just on there because some of the wire was exposed (probably due to the nut falling inside a few years ago). The old solenoid actually was clicking. But I replaced it tonight with a new one. Clicks, but cart doesn't move. Inline 10amp fuse does not blow, nor did any of the 4 micro-switches. Seems like either control box or motor at this point? Thanks

Sent from my XT1254 using Tapatalk

[bobsaladbar]

Originally Posted by bobsaladbar

I checked the glide box to make sure blue wire was on common (bottom) & green wire on top. The tape is just on there because some of the wire was exposed (probably due to the nut falling inside a few years ago). The old solenoid actually was clicking. But I replaced it tonight with a new one. Clicks, but cart doesn't move. Inline 10amp fuse does not blow, nor did any of the 4 micro-switches. Seems like either control box or motor at this point? Thanks

Sent from my XT1254 using Tapatalk

Or glide box, how do I test it? Just to recap, cart drove fine down to the end of the driveway, 1/4 mile, kids stopped, turned key off, went to start up again, and it wouldn't move. Thank you.

Sent from my XT1254 using Tapatalk