|
05-31-2015, 08:09 PM
|
#1 |
|
Not Yet Wild
Join Date: Apr 2015
Posts: 10
|
1987 motor swap
I have a 1987 ezgo with a 244cc robins motor on it. I want to swap it out with a different motor. But the way this cart is set up I don't know how I am going to do it. The driven clutch does not run parallel with the cart. It runs side to side. So my problem is if I put a motor in it. It would have to have the output shaft on the right hand side of the motor and it would have to spin clockwise for the cart to go forward. Or I could put the motor be hide the axle. Then the out put shaft could be on the left side of the motor and it could spin counter clockwise. But that's a lot of work. I would have to build a hole new engine bracket. Or I could put a motor with a shaft that comes out the back side of the motor. Instead of a chain. I could take the shaft and engineer it to go on the shaft that the driven clutch goes on. But the shaft would have to spine clockwise. I rebuilt the original motor from top to bottom. Even a new crank. New carb. rebuilt fuel pump. Every thing on the inside of the motor is brand new. It runs excellent. It just don't go fast enough for me. I would say it goes maybe 20 mph. Has plenty of power. It will climb a hill great. So I need something faster. I would even be willing to trade it to some one with something faster.
Last edited by robert30robert; 05-31-2015 at 08:21 PM.. Reason: Title wasn't bold |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
05-31-2015, 08:35 PM
|
#2 |
|
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: 1987 motor swap
A different motor won't necessarily make your cart run faster. Speed is determined by engine rpm, and you can't get much higher rpms than a 2-stroke. Your engine will be limited to about 5500rpm. That's if you put a lot of work into it. The 2pg design just doesn't allow for much higher rpms. 3pg is a different story.
Your best bet is to find an ME29 transaxle out of a 92-93 4-stroke Marathon and swap it in. That way you can use any 4-stroke motor you want, and build it for speed. |
|
|
|
|
06-01-2015, 09:30 AM
|
#3 |
|
Gone Wild
Join Date: Apr 2014
Location: Flint, MI, USA
Posts: 656
|
Re: 1987 motor swap
Is the governor hooked up?
Taller tires will reduce torque and hill-climbing but increase speed. |
|
|
|
|
06-01-2015, 01:45 PM
|
#4 |
|
Not Yet Wild
Join Date: Apr 2015
Posts: 10
|
Re: 1987 motor swap
I took the governor off of it. So that Is not the problem. Golf carts aren't meant to go fast. with the original motor.
|
|
|
|
|
06-01-2015, 02:45 PM
|
#5 | |
|
Gone Wild
Join Date: Apr 2014
Location: Flint, MI, USA
Posts: 656
|
Re: 1987 motor swap
Quote:
 Several of us disagreeLook up the thread/sticky with info on swapping carb and muffler for 1988 parts, and you'll see that there is potential. An ATV/sled muffler and a larger carb, if mechanically inclined, could be a nearly-free 5-10mph boost. Milling the head helps low/mid, cheap & easy. |
|
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 1978 Harley Motor swap to a CRF 450cc motor. pics inside.. gearing help???/ | Gas Harley Davidson | |||
| 1987 yamaha g1 w 440 arctic cat motor | Gas Yamaha | |||
| 1987 Ezgo motor swap ?'s | Electric EZGO | |||
| 1987 Club Car motor bench test | Electric Club Car | |||
| 1987 Marathon motor reassembly | Electric EZGO | |||
Linear Mode
