08-23-2015, 08:40 PM | #1 |
Not Yet Wild
Join Date: Jan 2015
Posts: 20
|
2 cycle swap?
Currently wanting to swap a 2 cycle with a 4 cycle motor. New to carts, I need idea possible problems etc. ways to deal with reverse etc.. I need ideas... Thanks!
Sent from my iPhone using Tapatalk |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-29-2015, 09:24 PM | #2 |
Not Yet Wild
Join Date: Jun 2015
Posts: 18
|
Re: 2 cycle swap?
From other threads that I have read it doesn't seem like a practical thing to do because the the 2 cycle engine is designed to turn in both directions, which is how the cart goes forward and backward. (I also have a 2 cycle golf cart.)
If you were going to convert to a 4 cycle you would have to deal with finding a new differential/transmission. Also,the shaft on most 4 cycle engines are parallel with the rear axel where as the 2 cycles are perpendicular. I hope I didn't just shoot down your project but at least you know what your getting into. |
08-30-2015, 07:40 AM | #3 |
Gone Wild
Join Date: Feb 2008
Location: Brooklyn, Michigan "Home of M.I.S."
Posts: 3,666
|
Re: 2 cycle swap?
Might be cheaper and less headaches to sell it and buy a 4 cycle cart. |
08-30-2015, 12:25 PM | #4 |
Gone Wild
Join Date: Apr 2015
Posts: 256
|
Re: 2 cycle swap?
As stated the easiest way would be to get a newer cart.
Next would be a complete transaxle swap. After that a comet trans. It would take a lot of fabrication and a drive chain or belt between the current rear end and this box. Then mount the engine just like the original is . fwd rev box http://www.ebay.com/itm/Comet-Forwar...4a677f&vxp=mtr Wrong set but could be used with chains. ultra cheap not a really good set. Designed for mini bikes. http://www.ebay.com/itm/3-4-CLUTCH-G...item27eca8984a Better clutch set 3/4 driven 1 in drive up to 16 hp but have seen them handle 25. Not very good on belts though. http://www.ebay.com/itm/40-Series-Go...ce695c&vxp=mtr |
09-06-2015, 07:25 PM | #5 |
Gone Wild
Join Date: Apr 2015
Posts: 256
|
Re: 2 cycle swap?
Local guy modded his without reverse. Its in Craigslist.
Do not care for it but you get the idea. Just use a go cart mount with the tranny listed above and mount it farther forward in the right place not like this one on top the axle. Then a coupler to the existing axle from the back of the trans. |
|
|
Similar Threads | ||||
Thread | Forum | |||
Marathon 2 Cycle to 4 Cycle Swap | Gas EZGO | |||
2 cycle g1 motor and 4 cycle g9 big block | Gas Yamaha | |||
Yamaha G1 (1979) 4 Cycle Motor Swap? | Gas Yamaha | |||
Engine swap 83 to 88 EZGO 2 cycle | Gas EZGO | |||
2 cycle to 4 cycle shifter conversion | Gas EZGO |